I went to pick up a spare engine drain plug to weld a hex bolt head to and found, to my surprise, DCJ had replaced the plug with a "conventional" style one with a large hex instead of the small Allen style.

DOC

_________________
2005 KJ CRD Ltd Detroit TrueTrac Bilsteins G2 GDE "HOT" ECU GDE TCM "Tow Tune" "euro" TC SEGR Weeks Elbow New HG at 130K ARPs Clean CAT aFe Filter Magnaflow Exhaust EHM Cumminos In-Tank Lift Pump Hayden Fan Clutch Nylon Fan VH Enabled with GDE lower shutoff point Recalibrated Temp Gauge Tekonsha Prodigy Sears P-1 ZDDP

yes it is much better.
just make sure you still use copper gasket with it

Yep, they actually did that change 3 years ago.

_________________
Mitchell Oates
'87 MB 300D Diamond Blue Metallic
'87 MB 300D - R.I.P. 12/08
'05 Sport CRD Stone White
Provent CCV Filter/AT2525 Muffler
Stanadyne 30 u/Cat 2 u Fuel Filters
Fumoto Drain/Fleetguard LF3487 Oil filter
V6 Airbox/Amsoil EAA Air Filter
Suncoast TC/Shift Kit/Aux Cooler
Kennedy Lift Pump/Return Fuel Cooler

Is there a current part number or is the old number still good?

Thanks

5191971-AA

_________________
2005 KJ CRD Ltd Detroit TrueTrac Bilsteins G2 GDE "HOT" ECU GDE TCM "Tow Tune" "euro" TC SEGR Weeks Elbow New HG at 130K ARPs Clean CAT aFe Filter Magnaflow Exhaust EHM Cumminos In-Tank Lift Pump Hayden Fan Clutch Nylon Fan VH Enabled with GDE lower shutoff point Recalibrated Temp Gauge Tekonsha Prodigy Sears P-1 ZDDP

They did that with mine too. Maybe I wasn't thankful enough; I replaced that one with a Fumoto. . .

_________________
In this war of lines, so many have been crossed. Where will it all stop?

2006 Deep Beryl Green CRD Sport *SOLD 1/22/12*
Provent, V6 Airbox, Fumoto, Samcos, GDE ECO & TCM Tune, Euro JK TC, Magnaflow Catback
245/70/16 Destination A/T's
Boiler's Radiator Skid Plate
Jeepin' By Al 2.5 inch Adjust-A-Strut Lift, JBA Gen 4.5 UCA's (6/5/10)