Anyone know where the 90 Degree ATDC (VM 1089) tool fits into. I found were the intake and exhaust pins go but where does this 3rd one go. Does it lock into the crankshaft somewhere?
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| VM 1089 90 ATDC tool location http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=48935 |
Page 1 of 1 |
| Author: | isx2009 [ Mon Jan 04, 2010 12:23 am ] |
| Post subject: | VM 1089 90 ATDC tool location |
Anyone know where the 90 Degree ATDC (VM 1089) tool fits into. I found were the intake and exhaust pins go but where does this 3rd one go. Does it lock into the crankshaft somewhere?
|
|
| Author: | MrMopar64 [ Mon Jan 04, 2010 12:59 am ] |
| Post subject: | Re: VM 1089 90 ATDC tool location |
The lower passenger side of the transmission adapter plate along the edge of the block. Rotate the engine around and around, the pin locates into a hole in the flexplate. I find it easier to use a thin screwdriver to find the hole the first time, then use the pin to lock it in place. |
|
| Author: | isx2009 [ Mon Jan 04, 2010 1:08 am ] |
| Post subject: | Re: VM 1089 90 ATDC tool location |
Thanks for the info. I thought that was where it goes. Alldata says to use a allen wrench. I guess that works too. Thanks again |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|