LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

dash board lights and chirping sound
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=55724		 Page 1 of 1
Author:  juge [ Sun Sep 19, 2010 2:17 am ]
Post subject:  dash board lights and chirping sound
hi guys
my 2003 jeep cherokee crd[thats how named in UK] has chirpimg sound all the time when idling when driving no sound.i have checked alternator pulley and changed all the pulleys as well.is it belt making this sound or tensoiner is getting warn ,because when see when sound is coming tensioner is jumping allot.so shall i change belt or tensioner.
and last week i have changed thermostat and after that on dashboard yelow warning lights keep comming and desepares after wile.warning lights look like squre and zigzag lines inside is it mean low coolant.
thanks all :D
Author:  Billwill [ Sun Sep 19, 2010 3:35 am ]
Post subject:  Re: dash board lights and chirping sound
Are you sure the clutch assembly on your alternator pulley is in good shape? They are known to give a lot of trouble.
After changing your thermostat did you bleed out all air bubbles from the system? You may have an air bubble causing the low fluid warning light. I hope you used the genuine red anti freeze fluid for your Jeep and not some aftermarket type.

You can display your error codes by doing the following:
Turn the ignition switch on/off in rapid succession four times then leave it on. Do not start the vehicle, just move the key to the first postion.

Your odometer will display any OBDII codes...the last one will be the most recent.
Let us know what those codes are and we can take it from there. :wink:
Author:  CATCRD [ Sun Sep 19, 2010 5:25 pm ]
Post subject:  Re: dash board lights and chirping sound
Classic signs of the alternator clutch pulley being locked up internally. Chirping and tensioner jumping.
Author:  WelshCherokeeCRD [ Sun Sep 19, 2010 6:21 pm ]
Post subject:  Re: dash board lights and chirping sound
I thought the first year for Jeeps to use the clutch on the alternator was 2005? Or was it on all CRDs across the board before that?

My first thought was a timing belt tensioner pulley.
Author:  CATCRD [ Sun Sep 19, 2010 7:12 pm ]
Post subject:  Re: dash board lights and chirping sound
I don't know the year cutoff. Is there a little round cover on the front of the pulley? Pop that off and see if there's red dust under it. That's clutch dust. It should be apparent at that point if it's a solid pulley or 2 piece clutched unit.
Author:  juge [ Mon Sep 20, 2010 12:18 am ]
Post subject:  Re: dash board lights and chirping sound
have to check alernator clutch again than.last time i moved belt and checked alternator pulley inside the alternator was moving together so it must be ok is it.no loose movement
.and for coolant do i have to open all the tabs to bleed the air.[bleeding tab and filling tab.]
thanks
Author:  boilermaker2 [ Mon Sep 20, 2010 3:02 pm ]
Post subject:  Re: dash board lights and chirping sound
Chirping will start just a few seconds after start-up if it is the alternator. There is a slight delay on our machines (this side of the pond) from when the machine is started and the alternator kicks in to start re-charging the battery. I assume (guess) that this is because the machine gives itself a few revolutions without drag so that the starter has one less part working against it. Once it kicks in, the chirping will begin...
Say goodbye to the clutch: :dead:
Boilermaker2
Author:  CATCRD [ Mon Sep 20, 2010 4:55 pm ]
Post subject:  Re: dash board lights and chirping sound
juge wrote:
have to check alernator clutch again than.last time i moved belt and checked alternator pulley inside the alternator was moving together so it must be ok is it.no loose movement


Then here you have the problem. The outside rim should be able to turn the inside when going clockwise. If you try to turn the pulley counterclockwise it should spin free of the inside shaft. It's a one-way clutch, kind of like a ratchet but smooth.
Author:  juge [ Mon Sep 20, 2010 9:08 pm ]
Post subject:  Re: dash board lights and chirping sound
thanks all have to :P check asa get some time.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/