LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

frozen EHM
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=57539		 Page 1 of 1
Author:  4sefed [ Tue Dec 14, 2010 5:29 pm ]
Post subject:  frozen EHM
So I made a couple of short trips this morning, and when I went out later in the afternoon i found out the hose for EHM had frozen.

When I pulled out into traffic the cloud of smoke was crazy huge. the smell of burn oil was very strong.

I pulled into a parking lot and started looking it over trying to figure out what was going on. when I looked at the bottom of the hose i use it was frozen.

So I used some side cutters to hack open the hose above the frozen plug, and once it's warms up a bit I'll have to re-route the hose so there isn't a place for the water to gather and freeze.

I'm glad I cought it early enough so I don't think any damage was caused, with the increased crankcase pressure it can cause seal problems.

Anyway just a warning to those with the EHM to be sure their routing doesn't hold the condensation
Author:  warp2diesel [ Tue Dec 14, 2010 5:40 pm ]
Post subject:  Re: frozen EHM
Pipe Insulation may help, cheap fix if it does.

Global Warming a Joke up there yet?
Author:  RAF 3829 [ Tue Dec 14, 2010 5:55 pm ]
Post subject:  Re: frozen EHM
Put a slit in the line farther up under the hood so there's still a spot for it to breathe if the end of the line freezes.
Author:  flman [ Tue Dec 14, 2010 6:06 pm ]
Post subject:  Re: frozen EHM
4sefed wrote:
I'm glad I cought it early enough so I don't think any damage was caused, with the increased crankcase pressure it can cause seal problems.

Anyway just a warning to those with the EHM to be sure their routing doesn't hold the condensation


You got lucky this time.
Author:  LibertyCRD [ Wed Dec 15, 2010 9:18 am ]
Post subject:  Re: frozen EHM
Odd, because my EHM was dunked under water, went through snow drifts, made it through the coldest weather in decades, and didn't give me a single problem last year. And I had it hanging down so low that you could get down on your knees and see it.

I'm about to hook it up again I think. I just don't like the idea of oil mist in my intercooler and intake.
Author:  flman [ Wed Dec 15, 2010 10:08 am ]
Post subject:  Re: frozen EHM
LibertyCRD wrote:
Odd, because my EHM was dunked under water, went through snow drifts, made it through the coldest weather in decades, and didn't give me a single problem last year. And I had it hanging down so low that you could get down on your knees and see it.

I'm about to hook it up again I think. I just don't like the idea of oil mist in my intercooler and intake.


Why don't you use the provent instead?
Author:  painemann [ Wed Dec 15, 2010 10:42 am ]
Post subject:  Re: frozen EHM
I had my tube running back near the rear axel, it's was engulfed in ice stuck up in the underbody. I cut it back near the drivers floor board.

Going to get a prevent soon!
Author:  LibertyCRD [ Wed Dec 15, 2010 11:05 am ]
Post subject:  Re: frozen EHM
flman wrote:
LibertyCRD wrote:
Odd, because my EHM was dunked under water, went through snow drifts, made it through the coldest weather in decades, and didn't give me a single problem last year. And I had it hanging down so low that you could get down on your knees and see it.

I'm about to hook it up again I think. I just don't like the idea of oil mist in my intercooler and intake.


Why don't you use the provent instead?



A) Cost
B) Aggrevation of installation
C) Aggrevation of maintenance
D) More clutter under the hood
E) Cost
F) The EHM works perfectly and better
Author:  flman [ Wed Dec 15, 2010 12:18 pm ]
Post subject:  Re: frozen EHM
painemann wrote:
I had my tube running back near the rear axel, it's was engulfed in ice stuck up in the underbody. I cut it back near the drivers floor board.

Going to get a prevent soon!


Well that is a long tube, no wonder it was so froze up. My Cummins had the CCV tube in front of the engine, where the fan would blow heat on it, it had a breather inside the outlet, with a tube that went up and then back down, it did not drip oil, freeze, or even smell. Maybe the fan helped to dissipate the odors?
Author:  changingtime [ Wed Dec 15, 2010 1:24 pm ]
Post subject:  Re: frozen EHM
I guess I don't completely understand why someone would want to do this mod?
Author:  audiboy86 [ Wed Dec 15, 2010 1:42 pm ]
Post subject:  Re: frozen EHM
It is to vent your ccv fumes to atmosphere instead of going back through your system. Where it causes problems like clogging up your MAP sensor and destroying hoses. I used copper hose and ran it straight down beside the turbo exhaust tubing no clogging problems here.
Author:  JL Rockies [ Wed Dec 15, 2010 2:01 pm ]
Post subject:  Re: frozen EHM
It's best not to mess around with such things as EHM and junk.
Author:  LibertyCRD [ Wed Dec 15, 2010 3:04 pm ]
Post subject:  Re: frozen EHM
JL Rockies wrote:
It's best not to mess around with such things as EHM and junk.



Yes, because the true enthusiast lets oil mist saturate all his hoses, intercooler, sensors, air filter, and intake and doesn't care about the repair bills down the road.
Author:  changingtime [ Wed Dec 15, 2010 3:17 pm ]
Post subject:  Re: frozen EHM
why would i want to send oil into the atmosphere? doesn't sound like a great idea.
Author:  Sir Sam [ Wed Dec 15, 2010 3:46 pm ]
Post subject:  Re: frozen EHM
changingtime wrote:
why would i want to send oil into the atmosphere? doesn't sound like a great idea.


Well first off it doesn't go into the atmosphere, it condenses in the hose.

Second, think of it this way, even the little bit of emissions that gets out into the atmosphere doesn't go into the engine, since it doesn't clog up things like the MAP(which causes lots more problems including dramatically elevated emissions), and cause boost hoses to fail(fair amount of resources go into making those and disposing of them), I could easily make the argument that the little bit of directly added crap greatly is greatly offset by the other benefits.

So the real question is, why WOULDN'T you want to do this?

Also, you should check out the noob guide:
viewtopic.php?f=5&t=54207
Author:  painemann [ Wed Dec 15, 2010 7:18 pm ]
Post subject:  Re: frozen EHM
flman wrote:
painemann wrote:
I had my tube running back near the rear axel, it's was engulfed in ice stuck up in the underbody. I cut it back near the drivers floor board.

Going to get a prevent soon!


Well that is a long tube, no wonder it was so froze up. My Cummins had the CCV tube in front of the engine, where the fan would blow heat on it, it had a breather inside the outlet, with a tube that went up and then back down, it did not drip oil, freeze, or even smell. Maybe the fan helped to dissipate the odors?


No it didn't freeze up yet, but I don't want it to so I shortened it!
Author:  Radman [ Sat Dec 18, 2010 9:54 am ]
Post subject:  Re: frozen EHM
I have seen many VW TDI's blow their turbo seals due to this mod. Remove in winter is my suggestion to avoid potential problems. Oil in your intake is really not that harmful. However when it mixes with the EGR this is where t starts to block. Chiptuning is the best way to eliminate / reduce the EGR and get more power to boot!
Author:  RJM [ Sat Dec 18, 2010 5:07 pm ]
Post subject:  Re: frozen EHM
When done properly, you will not have issues in the cold.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/