Ok, I am a little stumped on this one...... when I shut off the CRD and when I start it I am getting a very strong raw diesel smell from the intake side of the engine, I cannot see any signs of leaks, nothing dripping on the ground but that smell of diesel.... if there are any suggestions please....

_________________
2005 Liberty CRD sport
FrankenLift with JPA's UCA
Moab wheels with General Grabber AT2 tires
Bull nose push bar with KC Daylighters
Mopar light bar
Cobra anniversary CB
full skids
GDE Hot tune & GDE TCM tune
Euro TC

Return lines off the injectors?? Look for diesel pooling around the cavity that contains the injectors.

_________________
06 LIMITED 100000miles, MAGNAFLOW, HOMEBUILT CCV FILTER, POLAR PAD, 02 AIRBOX, CUMMINS LIFT PUMP, SEGR, PILLAR GAUGE POD, CAT FILTER MONITOR, SPYDER TRAX, ALWAYS A LITTLE TWO STROKE OIL OR BIO, WATER/METH INJECTION

absolutely no signs anywhere in the engine bay of fuel, looked at the injectors as well.... wonder if it could be with the pump???

_________________
2005 Liberty CRD sport
FrankenLift with JPA's UCA
Moab wheels with General Grabber AT2 tires
Bull nose push bar with KC Daylighters
Mopar light bar
Cobra anniversary CB
full skids
GDE Hot tune & GDE TCM tune
Euro TC

It could be leaking off the back of the high pressure pump and then down into that sound absorbing mat that's on the front skid plate? Maybe that's why you don't see drips. It would be worth a look under the plate.

_________________
05CRD: GDE Hot ECU & TCM tunes, Provent, Cat filter, Facet lift pump, TransGo kit, Florida TC, Samcos, stainless brake lines, HDS thermostat, Renegade light bar,
Bilstein adjustables, Al's Gen 4.5 Arms, 235/85-16 Duratracs, DTT rear, Elocker front, EVIC+TPMS, Turbo timer, McNally pillar gauges, Weeks Stage II kit.

How many miles since last fuel filter change? Check for leakage at the fuel return block/lines on side of intake manifold. Best to check the high pressure fuel pump from the top and bottom of engine. Any fuel smell on the engine cover insulation? Hopefully you can get it pinpointed.

_________________
Providers of wholly developed aftermarket solutions for the KJ CRD.
(248) 977 - 9531