I suggest you read Sir Sam's Nood guide
There you'll find where you can down load the fsm and have all the pages
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Help GLOW PLUG PROBLEM - How to Check if the Module http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=57789 |
Page 1 of 1 |
| Author: | 06PeakBagger [ Sun Dec 26, 2010 6:52 pm ] |
| Post subject: | Help GLOW PLUG PROBLEM - How to Check if the Module |
On first cold start (Houston Metro Area) got code P1261, P1263, P1265, P1267. How do I check Bosch Module. I think it is the one behind the battery. I need a diagram or the page in the service manual that show the location as in the jeep. |
|
| Author: | Joe Romas [ Sun Dec 26, 2010 8:24 pm ] |
| Post subject: | Re: Help GLOW PLUG PROBLEM - How to Check if the Module |
I suggest you read Sir Sam's Nood guide There you'll find where you can down load the fsm and have all the pages
|
|
| Author: | 06PeakBagger [ Mon Dec 27, 2010 3:03 am ] |
| Post subject: | Re: Help GLOW PLUG PROBLEM - How to Check if the Module |
So i checked the resistance (using a fluke meter) of the glow plugs from the connector - Each had a omh reading above 200 |
|
| Author: | ATXKJ [ Mon Dec 27, 2010 8:43 pm ] |
| Post subject: | Re: Help GLOW PLUG PROBLEM - How to Check if the Module |
>200 is dead - .5 to 1 is good (and a lot of meters won't read that low) although I don't know that I would try to replace them until the metallic versions are available. when I was having glow plug problems I plugged in the block heater overnight - don't need the glow plugs and you get instant heat in the morning. |
|
| Author: | adrianmiura [ Mon Dec 27, 2010 8:52 pm ] |
| Post subject: | Re: Help GLOW PLUG PROBLEM - How to Check if the Module |
who is making the metallic versions ? |
|
| Author: | ATXKJ [ Mon Dec 27, 2010 9:14 pm ] |
| Post subject: | Re: Help GLOW PLUG PROBLEM - How to Check if the Module |
adrianmiura wrote: who is making the metallic versions ? pretty sure it'll still be Bosch - however the limiting factor is that Jeep has to tweak the engine controller - it'll use a different voltage from the ceramic versions. http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=56766&start=40 |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|