I would like to hear from people that ran the in-tank lift pump mod and which p/n fuel pump you are using. From what I understood, the airtex E7181M is discontinued for the E7187M. Anybody is running the E7187M? Also, would anybody have the Carter, Cummins, Mopar or any other fuel pump manufacturer equivalent p/n for the E7187M?

Thanks.

_________________
2006 CRD KJ, 245/70R16 A/T KO, GDE eco tune, ARB bull bar, OME lift, AVIC-N4, turbo timer, pulsetech solargizer, Racor CCV3500, Racor 245R122 fuel head, Caterpillar battery, oem light bar, KC lights, HID fog lts, cb, ...

This is the part number I ordered from one of the online mopar parts stores: 5143160AB

_________________
2006 CRD Limited Dk Khaki
InMotion S-II, GDE TCM, Cummins Lift Pump, Mishimoto CAC hoses
Cooper Discoverer ATP LT245/75, Rola roof basket, JCR S3 sliders
OME lift+JBA UCA's, custom front hitch receiver, Mile Marker winch
All J Products rear cargo shelf
Sips biodiesel as if it were 12 y/o Scotch

I used the pump and canister from my 06 Cummins. The libby's canister is the Dodge. Combined witha Stanadyne FM100 fuel filter, this system works great. Pretty much looks factory, except for my wiring. I had the Faceut external pump on the frame for a little while, but this is much better. Well worth the time and effort.

_________________
HERS:'16 WK2 Limited EcoDiesel - GDE hot
HIS: '06 Liberty CRD - EHM , GDE eco, Brite Box, Stanadyne FM100, Cummins lift pump, OME lift
'06 Dodge/Cummins - Play truck; a couple of fans, a proper cam shaft, and man handled electrons by EFILive 500/900
'01 Dodge/Cummins - Work truck; Lots of mods

What's the p/n of your lift pump from your 2006 cummins?

_________________
2006 CRD KJ, 245/70R16 A/T KO, GDE eco tune, ARB bull bar, OME lift, AVIC-N4, turbo timer, pulsetech solargizer, Racor CCV3500, Racor 245R122 fuel head, Caterpillar battery, oem light bar, KC lights, HID fog lts, cb, ...

Airtex E7181M from Autozone here in Round Rock, TX.. $173.00 = tax. I used the electrical connectors robbed out of the old units lower connector, right under the top plate. If one uses the connectors, be sure to clean them well before soldering on new wire! Works like a champ and the Libby is snappier than ever. I still have an air in fuel issue at extended WOT though, gonna scrap that factory filter head for a quality aftermarket one.

_________________
05 No F37!
GDE HOT
In-tank Lift Pump
Dynomax Super Turbo 2.5
EU TC
Hankook ATm's (245's)
Factory Crap Catcher Floor Mats

Sold 05/11.

Just put it in last month. Was able to find older stock 5143160AA Dodge pump.

Airtex is oem mfr of the Jeep and Dodge fuel cannister

Good tradeout, Tinman - had any of the usual 'loss of fuel supply' problems at start\stop events encountered by so many other Ram fuel 'upgrades', necesitating "draw straws" and many other kinky 'fixes'?

_________________
'05 CRD Limited
Pricol EGT, Boost
GDE Hot '11; EDGE Trail switched
SEGR; Provent; Magnaflow;
Suncoast T\C, Transgo Tow'n'Go switch;
Cummins LP module, Fleetguard filter, Filterminder
2.5" Daystar f, OME r; Ranchos; K80767's, Al's lifted uppers
Rubicons, 2.55 Goodyears
Four in a row really makes it go