LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Do we want a Sticky thread for KJ FSM errors?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=58581
Page 1 of 1

Author:  warp2diesel [ Fri Jan 28, 2011 1:14 pm ]
Post subject:  Do we want a Sticky thread for KJ FSM errors?

Needless to say, there a more than a couple errors in the KJ FSM.
But like most of us, I forget them until I need to do the job again.
Hope the Mods read the Tea Leaves and follow our wishes.

Author:  Sir Sam [ Fri Jan 28, 2011 4:13 pm ]
Post subject:  Re: Do we want a Sticky thread for KJ FSM errors?

it probably doesn't matter where it really goes, and long at its easy to find and can be linked from the appropriate areas(like the post where I put up the FSMs, or in the noob guide).

Author:  Joe Romas [ Fri Jan 28, 2011 8:14 pm ]
Post subject:  Re: Do we want a Sticky thread for KJ FSM errors?

I voted for the tech section but I just wish people would use it for what it was intednded for instead of questions :goink:

Author:  changingtime [ Fri Jan 28, 2011 9:20 pm ]
Post subject:  Re: Do we want a Sticky thread for KJ FSM errors?

what is an FSM

Author:  warp2diesel [ Fri Jan 28, 2011 10:28 pm ]
Post subject:  Re: Do we want a Sticky thread for KJ FSM errors?

changingtime wrote:
what is an FSM


Factory Service Manual

Author:  sidebrake [ Sat Jan 29, 2011 12:56 am ]
Post subject:  Re: Do we want a Sticky thread for KJ FSM errors?

Absolutely.


I think it also might be helpful if we can add things that are simply omitted. The cooling chapter, for instance, doesn't speak to the CRD engine in very much detail.

Author:  Sir Sam [ Sat Jan 29, 2011 1:15 am ]
Post subject:  Re: Do we want a Sticky thread for KJ FSM errors?

changingtime wrote:
what is an FSM


Factory Service Manual - look in the noob guide for the link to the download.

Author:  dkenny [ Sun Jan 30, 2011 4:18 pm ]
Post subject:  Re: Do we want a Sticky thread for KJ FSM errors?

why not in both sections?

I vote yes to either section..there some major mistakes that have caused all of us some grief..IP and timing comes to mind first.

-dkenny

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/