camo wrote:
well, a week ago took it to riveroaks jeep and they did a tranny service (flush, filter, oil) and they said it all looked ok. however, I just chek the tanny oil today and before starting the crd (cold) the fuild showed at the highest hot mark dot of the tranny dipstick, then i started it and drove it about 3 miles and recheck, this time the oil was a bit lower than the lower hot mark dot of the the tranny dipstik. Does that mean something out of the ordinary? could it be whats causing the issues?
thnx
Your jumping all over the place with your "surge"
Stop and take a deep breath. Then check your fluid properly. Start the jeep after letting it sit overnight and move the shifter between all the gears and with it running check the fluid level. It should be at the COLD level. Then drive it long enough to get it totally warmed up, maybe 5 miles or so. Then check the level. It should be in the HOT level.
Have you read Sir Sam's noob guide and downloaded the FSM
Now reading one of your posts you said:
"I get to a stop sign, brake gradually until dead stop, wait 3 sec then release the brake and before I even hit the gas again I fell the surge as if someone bump my rear"What your discribing in that situation sounds like the slip joint in the rear driveshaft binding on the splines of the transmission. It's a simple fix of removing the drive shaft and putting some grease on the splines shaft

It happens because when your stopping the rear end of the jeep raises up and the drive shaft moves outward from the transmssion. Then when you let off the brakes the rear settles back to normal and the drive shaft then needs to slide back into the transmission. It is at this time the driveshaft binds and you get what is best discribed as a "feeling" that something is amiss. I've owned 3 automatic XJ's (cherokees) and they have all done this untill I lubed the slip joint. This sensation can vary from being just noticable to good thump. My CRD has recently started doing it too, I suspect the proper grease or any grease was not used when the TC was replaced, and I've choosen to ignore for now
