| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Transmission problems? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=64376 |
Page 1 of 1 |
| Author: | 4x4kingx889 [ Wed Dec 28, 2011 9:27 pm ] |
| Post subject: | Transmission problems? |
Recently My transmission has been acting up It feels like its slipping when you put it to the floor I changed both transmission filters and fluid It is also throwing these codes P1189,P0841,P0700 I tryed looking them up but I am not sure what they mean |
|
| Author: | racertracer [ Thu Dec 29, 2011 12:12 am ] |
| Post subject: | Re: Transmission problems? |
Before you changed filter and fluid, how many miles on tranny with original fluid and filter. |
|
| Author: | 4x4kingx889 [ Thu Dec 29, 2011 12:58 am ] |
| Post subject: | Re: Transmission problems? |
strange I looked up the first code and came across that the sensor on the airbox must have a strong connection so I went and ziptied it and now my jeep's power is back and the transmission is fine? was my jeep in limp mode? |
|
| Author: | GreenDieselEngineering [ Fri Dec 30, 2011 11:00 pm ] |
| Post subject: | Re: Transmission problems? |
yes it was in limp mode due to the airbox sensor. |
|
| Author: | 4x4kingx889 [ Sat Dec 31, 2011 5:02 pm ] |
| Post subject: | Re: Transmission problems? |
would that cause the tranny codes to come up also? |
|
| Author: | papaindigo [ Sat Dec 31, 2011 5:59 pm ] |
| Post subject: | Re: Transmission problems? |
As I recall P0700 is just telling you that there are 1 or more tranny codes stored. P0841 is a tranny shift related code, don't know about P1189. My bet is that limp mode can throw these codes but since you have cured the cause of the limp mode these codes should self clear after a few drive cycles. I know before I figured out how to deal with, not fix, the tranny fluid drain back problem that when I had the "shudder/stall" I would sometimes get a tranny code and CEL but they both went away after just few start cycles. |
|
| Author: | LMWatBullRun [ Sun Jan 15, 2012 10:35 am ] |
| Post subject: | Re: Transmission problems? |
I am also getting a P0700 code, related to the overdrive. When driving up and down hills, it appears that the transmission gets confused, and I sometimes get a hard clunk when the OD kicks in, with a CEL coming on and the P0700 code associated. No problem when running with OD off. 05 CRD has about 80K miles. No history from PO. Fluid appears to be fresh and is filled to the mark. My thoughts are- Possible bad TCM module or sensor? trans filter clogging? Worn pump? bad programming of TCM? Would like suggestions on diagnosing/correcting this problem. I'm thinking of the GDE flash, but want to do the right things in the right order. Thoughts or suggestions welcomed. LMW |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|