I put in neutral and put in part time of full time four wheel just fine. But four wheel low seems hard. It will
go but i have work for it for a while. It's seem hard to get out as well. Works great when it's in four wheel low. It was just rebuilt.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Seems hard to get 4 wheel low http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=64821 |
Page 1 of 1 |
| Author: | jlgail4309 [ Sun Jan 22, 2012 9:39 pm ] |
| Post subject: | Seems hard to get 4 wheel low |
I put in neutral and put in part time of full time four wheel just fine. But four wheel low seems hard. It will go but i have work for it for a while. It's seem hard to get out as well. Works great when it's in four wheel low. It was just rebuilt.
|
|
| Author: | bugnout [ Mon Jan 23, 2012 12:25 pm ] |
| Post subject: | Re: Seems hard to get 4 wheel low |
You should be rolling when you shift from nuetral into 4 lo. |
|
| Author: | nissanfrontier [ Tue Jan 24, 2012 10:48 pm ] |
| Post subject: | Re: Seems hard to get 4 wheel low |
On wranglers lets say your in 4low come to complete stop on level ground wheels straight no bind in system, you can get jeep rolling just little bit then push forward should go in or out. The bind is what causes 4wd not to go in or out. I always have wheels straight either back up and get it in or forward. |
|
| Author: | JL Rockies [ Wed Jan 25, 2012 11:49 am ] |
| Post subject: | Re: Seems hard to get 4 wheel low |
This is covered in the 4x4 section out in the scary world outside of the CRD section. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|