| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| vibration damper - dumb question http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=66276 |
Page 1 of 1 |
| Author: | Deezel [ Sat Apr 07, 2012 2:56 pm ] |
| Post subject: | vibration damper - dumb question |
Saturday CRD timing belt fun....first time. Do you need to remove the 4 small bolts AND the big 21mm bolt to get the vib damper off? Also, does it come off easy or do I need to hunt for my puller and correct bolts for it? Thanks!! |
|
| Author: | MrMopar64 [ Sat Apr 07, 2012 6:18 pm ] |
| Post subject: | Re: vibration damper - dumb question |
You need to remove only the 4 smaller bolts. It should come right off with minimal effort unless it's somehow rusted on a little bit. Shouldn't need a puller or anything, maybe just a screwdriver to knock it loose with. The big bolt holds on the crank adapter that the timing belt is cogged to. |
|
| Author: | jeepdan [ Sun Apr 08, 2012 1:24 pm ] |
| Post subject: | Re: vibration damper - dumb question |
Place a piece of heavy cardboard against the radiator to protect it before removing the damper pulley. Just in case the damper comes off suddenly. |
|
| Author: | ChesterCRD [ Sun Apr 08, 2012 3:32 pm ] |
| Post subject: | Re: vibration damper - dumb question |
I used an air hammer around the edge of the damper pulley after removing the four bolts. It was just some surface rust holding it on there and that loosened it right up. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|