| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Quick connect plastic fittings at the top of the tank http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=66532 |
Page 1 of 1 |
| Author: | Herk [ Sat Apr 21, 2012 10:51 am ] |
| Post subject: | Quick connect plastic fittings at the top of the tank |
Today i planning to drop my gas tank so I can change out these lines. Can I just drop it partially then change them or or disconnect everything and lower to the ground? This is my last step in trying to fix the stalling issues. AK |
|
| Author: | msilbernagel [ Sun Apr 22, 2012 2:14 am ] |
| Post subject: | Re: Quick connect plastic fittings at the top of the tank |
If you can put it up on jack stands and go under it from the driver's side in front of the axle, you might be able to drop the front of the tank without disconnecting the filler tube... and get access to the connectors. Did you get new or different connectors? Mark |
|
| Author: | Herk [ Sun Apr 22, 2012 10:40 am ] |
| Post subject: | Re: Quick connect plastic fittings at the top of the tank |
Thanks for the input and yes I put new OME lines on. Test driving it today and hope this fixes the stalling out issue. AK |
|
| Author: | Herk [ Sun Apr 22, 2012 10:54 pm ] |
| Post subject: | Re: Quick connect plastic fittings at the top of the tank |
Well it didn't fix it. Maybe injectors as talked about on Mozzio post since he just about replaced everything. Except I have no starting issue just stalling once way from home.AK |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|