| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| ODOMETER stops http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=69255 |
Page 1 of 1 |
| Author: | cruiserfreak [ Tue Jun 19, 2012 9:07 am ] |
| Post subject: | ODOMETER stops |
My odometer stops, when the ABS and BRAKE idiot lights come on. The idiot lights are not on all the time. The idiot lights seem to light up when I hit a pothole or rough part of the road, important word here - seems - Any ideas CRDers |
|
| Author: | dgeist [ Tue Jun 19, 2012 9:25 am ] |
| Post subject: | Re: ODOMETER stops |
cruiserfreak wrote: My odometer stops, when the ABS and BRAKE idiot lights come on. The idiot lights are not on all the time. The idiot lights seem to light up when I hit a pothole or rough part of the road, important word here - seems - Any ideas CRDers Sounds like the sensor on the top of the rear diff pumpkin (either the connector or the sensor, actually). It'll make your calculated mileage go in the pooper if you have an EVIC as well. Mine went out for no good reason and was replaced under warranty a couple years back. Dan |
|
| Author: | ihatemybike [ Tue Jun 19, 2012 10:41 am ] |
| Post subject: | Re: ODOMETER stops |
On ours the parking brake cable rubbed the wires for the speed sensor on the rear differential, twice. First time the entire harness was replaced, only time we let a dealer work on Eugene, wasn't cheap. Second time we wired in a new pig tail leaving longer leads and added zip ties so the parking brake cable and the wires no longer rub. Second repair has well outlasted the first. |
|
| Author: | bugnout [ Tue Jun 19, 2012 12:55 pm ] |
| Post subject: | Re: ODOMETER stops |
Don't assume the wires are good to the speed sensor on the pumpkin. I had an open wire right where it entered the connector. No break in the insulation or any other indication it was bad. |
|
| Author: | crd351 [ Thu Jun 21, 2012 12:26 pm ] |
| Post subject: | Re: ODOMETER stops |
its the right front wheel bearing that is were the crd takes it odometer pick up just was though all that thislast month on mine |
|
| Author: | cruiserfreak [ Fri Jul 20, 2012 8:49 pm ] |
| Post subject: | Re: ODOMETER stops |
Spot On gents. The wire loom had rubbed through one wire. No pigtail available from dealer, but was able to repair. Thanks for the input |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|