LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

EGR cooler hose - anyone have a part number?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=71781		 Page 1 of 1
Author:  ColoCRDx2 [ Tue Sep 25, 2012 5:43 pm ]
Post subject:  EGR cooler hose - anyone have a part number?
I need to replace this hose, and can't find a part number. It's not in the either of the parts fiche's that I've got (seems that it should be in illustration 25-210). I spent an hour with the Jeep parts counter guy while he was on the phone with Chrysler's "specification department", whatever that is - to no avail.

(If the picture is not clear, or if you've never been in there and actually seen this - the hose I'm looking for is the longer of the two that hooks into the EGR cooler. It goes up and turns 90 degrees into the side of the block under the intake manifold).

Thanks if you can help,

Doug

Image

BTW - the two little 1/4" diameter hoses that run up to the EGR valve itself are almost $50 each at the dealer!
Author:  smoking Gun [ Tue Sep 25, 2012 8:01 pm ]
Post subject:  Re: EGR cooler hose - anyone have a part number?
I just replace the same hose when I did a cylinder head replacement. The Part number of that hose is 5142791AA, think I paid around $8.00 from wermopar.com
Author:  ColoCRDx2 [ Sat Oct 13, 2012 10:28 am ]
Post subject:  Re: EGR cooler hose - anyone have a part number?
Yessir, that was it, thanks.

When you go to the dealer looking for this hose, the parts system illustration only shows the shorter, more forward hose. But then they have numbers for both, listed as either the 4 inch or 6 inch hose.... even though the "6 inch" one is at least 12" long.

Funny, I thought that hose lengths were usually exaggerated in the other direction. :wink:

Doug
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/