racertracer wrote:
Can the existing glow plug relay be used with the new OEM metal glow plugs?
The Glow Plug Module has to be replaced and the ECU re-programmed before connecting power to the new 5 volt plugs.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Relay for Glow Plugs http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=74004 |
Page 1 of 2 |
| Author: | racertracer [ Sun Feb 03, 2013 10:17 am ] |
| Post subject: | Relay for Glow Plugs |
Can the existing glow plug relay be used with the new OEM metal glow plugs? |
|
| Author: | Dennis MacGyver [ Sun Feb 03, 2013 4:57 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
From what I read, when you upgrade to the new glow plugs (which have a different voltage requirement than the old ceramic plugs), a new relay is required AND the ECU has to be reprogrammed to the new voltage. Kieth from GD can do the change to your ECU if you have a tune from him. You have to do this in the right sequence otherwise you can blow the ECU up because of the voltage change to the new plugs. |
|
| Author: | Billwill [ Mon Feb 04, 2013 2:51 am ] |
| Post subject: | Re: Relay for Glow Plugs |
racertracer wrote: Can the existing glow plug relay be used with the new OEM metal glow plugs? The Glow Plug Module has to be replaced and the ECU re-programmed before connecting power to the new 5 volt plugs.
|
|
| Author: | racertracer [ Mon Feb 04, 2013 3:02 am ] |
| Post subject: | Re: Relay for Glow Plugs |
Thank you |
|
| Author: | papaindigo [ Mon Feb 04, 2013 9:37 am ] |
| Post subject: | Re: Relay for Glow Plugs |
If you go with the OEM 5v replacement plugs from what I've seen they are sold as a "kit" of 4 plugs and a controller for like $125 last I looked. |
|
| Author: | kjjet [ Mon Feb 04, 2013 10:35 am ] |
| Post subject: | Re: Relay for Glow Plugs |
racertracer wrote: Can the existing glow plug relay be used with the new OEM metal glow plugs? If you replace the original 7v plugs with 7v metal there is no other requirements needed (drop in replacement) This is what i want to do, but they cost more and harder to get. 7V Steel ETEcno1 P/N GX3123 direct original replacement If you replace the original 7v plugs with 5v metal, Yes a relay and flash to your ECU is required. |
|
| Author: | ChooChooman74 [ Mon Feb 04, 2013 11:45 am ] |
| Post subject: | Re: Relay for Glow Plugs |
Relay has the same Bosch number..... Hmmmmm Sent from my Nexus 7 using Tapatalk HD |
|
| Author: | Srytrucker [ Mon Feb 04, 2013 1:19 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
Can I get a part number for the kit ie 4 plugs and relay thanks. |
|
| Author: | papaindigo [ Mon Feb 04, 2013 1:38 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
Kit PN is 68090434AA and prices are all over the map right now. Drop in 7v replacements, no controller or flash needed, can be obtained from http://www.dieselglowplug.com/gx3123-di ... svli5qq877 . Depending on $ vs Euro they run about $180 for 4 delivered, can use Visa/MC, and delivery seems to take a week or two via regular shipping. |
|
| Author: | kjjet [ Mon Feb 04, 2013 2:04 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
papaindigo wrote: Kit PN is 68090434AA and prices are all over the map right now. Drop in 7v replacements, no controller or flash needed, can be obtained from http://www.dieselglowplug.com/gx3123-di ... svli5qq877 . Depending of $ vs Euro they run about $180 for 4 delivered, can use Visa/MC, and delivery seems to take a week or two via regular shipping. Yes papaindigo is correct: but Just to keep it clear. option: 1. 5v steel kit P/N 6809034AA (4ea steel GP, relay) & you need to have ECM flashed. 2. 7V steel ETEcno1 P/N GX3123 direct original replacement. No flash. |
|
| Author: | racertracer [ Mon Feb 04, 2013 2:38 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
I not positive but I think GDE will GP flash the OEM ECU for $50.00. ????? |
|
| Author: | kjjet [ Mon Feb 04, 2013 3:29 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
racertracer wrote: I not positive but I think GDE will GP flash the OEM ECU for $50.00. ????? YES...Keith is the man! |
|
| Author: | papaindigo [ Mon Feb 04, 2013 3:53 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
racer and kjjet are correct but IIRC that $50 is only applicable if you already have a GDE tune. |
|
| Author: | racertracer [ Mon Feb 04, 2013 4:26 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
I believe keith said that the GPflash cost was valid for an OEM ECU also, not just the GDE tune. |
|
| Author: | papaindigo [ Mon Feb 04, 2013 5:13 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
I had not heard that but could be true only Keith knows for sure I assume. I went with the 7vs but have yet to install them, maybe next week. |
|
| Author: | kjjet [ Mon Feb 04, 2013 10:27 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
papaindigo wrote: I had not heard that but could be true only Keith knows for sure I assume. I went with the 7vs but have yet to install them, maybe next week. To bad your down in the warm weather. I would like to here from people using them up here below 20 degrees F |
|
| Author: | Billwill [ Tue Feb 05, 2013 7:49 am ] |
| Post subject: | Re: Relay for Glow Plugs |
ChooChooman74 wrote: Relay has the same Bosch number..... Hmmmmm Sent from my Nexus 7 using Tapatalk HD What is the part number of this relay you are refering to? I do not see an relevant "relay" in the circuit diagrams...only the Glow Plug Controller. 
|
|
| Author: | racertracer [ Tue Feb 05, 2013 8:15 am ] |
| Post subject: | Re: Relay for Glow Plugs |
Billwill wrote: ChooChooman74 wrote: Relay has the same Bosch number..... Hmmmmm Sent from my Nexus 7 using Tapatalk HD What is the part number of this relay you are refering to? I do not see an relevant "relay" in the circuit diagrams...only the Glow Plug Controller. Billwill, you may have hit on something. Is it a controller or a relay? ChooChooman, I was wondering the same thing... others have mentioned that the part numbers of the old and new (relay/controller) are the same. Hence the reason for my post. What are the part number of the old and new? I don't believe that Chrysler would revise a part without an update to the part number. |
|
| Author: | LMWatBullRun [ Tue Feb 05, 2013 8:50 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
kjjet wrote: papaindigo wrote: I had not heard that but could be true only Keith knows for sure I assume. I went with the 7vs but have yet to install them, maybe next week. To bad your down in the warm weather. I would like to here from people using them up here below 20 degrees F If you switch the key on and off 3 or 4 times they work fine at 10 degrees F. They seem to stay on longer than the ceramics did on the first go. I turn the key on the first time, give a 2 count, turn the key off then immediately back on for a two count, and repeat another time or two. Starts right up, not much smoke. What I would like to see is GDE developing a tune for the GPs that adds just a leetle more on time to the GPs.... |
|
| Author: | ChooChooman74 [ Tue Feb 05, 2013 9:48 pm ] |
| Post subject: | Re: Relay for Glow Plugs |
LMWatBullRun wrote: kjjet wrote: papaindigo wrote: I had not heard that but could be true only Keith knows for sure I assume. I went with the 7vs but have yet to install them, maybe next week. To bad your down in the warm weather. I would like to here from people using them up here below 20 degrees F If you switch the key on and off 3 or 4 times they work fine at 10 degrees F. They seem to stay on longer than the ceramics did on the first go. I turn the key on the first time, give a 2 count, turn the key off then immediately back on for a two count, and repeat another time or two. Starts right up, not much smoke. What I would like to see is GDE developing a tune for the GPs that adds just a leetle more on time to the GPs.... I never had luck switching on and off. Actually had a witch of a time getting her started. Sent from my DROID BIONIC using Tapatalk 2 |
|
| Page 1 of 2 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|