| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| p1261 code.... GRRRR http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=74641 |
Page 1 of 1 |
| Author: | Tree Catcher [ Sat Mar 23, 2013 6:39 pm ] |
| Post subject: | p1261 code.... GRRRR |
I have the p1261 code and can't get rid of it. I just spent four hours and replaced my glow plugs with the steel glow plugs and still have the nagging code. Anyone have any ideas on where to next? On the good side replacing the GP's weren't that hard or time consuming. I just followed the great write up on how to change them thanks to LOST. Thanks Sean |
|
| Author: | WolverineFW [ Sat Mar 23, 2013 8:19 pm ] |
| Post subject: | Re: p1261 code.... GRRRR |
Did you clear the code with a code reader when you were done? If not, did you drive enought cycles to clear the code on its own? |
|
| Author: | Tree Catcher [ Sat Mar 23, 2013 8:34 pm ] |
| Post subject: | Re: p1261 code.... GRRRR |
Yep we went over and tried to have the code cleared and was still there.. How many drive cycles does it take to go away? |
|
| Author: | Hexus [ Sat Mar 23, 2013 10:27 pm ] |
| Post subject: | Re: p1261 code.... GRRRR |
Remind me what 1261 is? Is that #3? Checking FSM... I don't see a 1261 in the Service Manual.... |
|
| Author: | Hexus [ Sat Mar 23, 2013 10:27 pm ] |
| Post subject: | Re: p1261 code.... GRRRR |
Remind me what 1261 is? Is that #3? Checking FSM... I don't see a 1261 in the Service Manual.... |
|
| Author: | TJ2 [ Sat Mar 23, 2013 10:32 pm ] |
| Post subject: | Re: p1261 code.... GRRRR |
I'm seeing a 'glow plug #1 control circuit low' |
|
| Author: | Hot Stuff [ Sat Mar 23, 2013 11:06 pm ] |
| Post subject: | Re: p1261 code.... GRRRR |
Same code I have. I cant get it to clear either. But not exactly sure what the code means or how to to remedy it. Just that it says 'glow plug 1 control circuit low'. |
|
| Author: | Hexus [ Sun Mar 24, 2013 9:19 am ] |
| Post subject: | Re: p1261 code.... GRRRR |
Replace the ASD relay. $7 Talk to me after. |
|
| Author: | Tree Catcher [ Sun Mar 24, 2013 4:05 pm ] |
| Post subject: | Re: p1261 code.... GRRRR |
I hopped into the jeep this morning and the light was gone!!!!  I guess I just had to cycle the engine through three hot/cold cycles in order for the code to clear. Kind of wonder why the code reader was not able to clear it. Either way I am glad to have the ceramic glow plugs out of there.Thanks for all the help Sean |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|