| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Looking for a good repair shop http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=75122 |
Page 1 of 1 |
| Author: | jburford [ Wed May 01, 2013 11:34 pm ] |
| Post subject: | Looking for a good repair shop |
I think I have a head gasket leak. Since this will be very expensive job I want someone who has experience with the Liberty CRD engine. I would greatly appreciate any recommendations. Shops in the Detroit area or St. Louis area would be preferred. John Burford 2006 CRD Sun Coast TC GDE Hot Tune GDE trans reprogram |
|
| Author: | DOC4444 [ Thu May 02, 2013 8:34 am ] |
| Post subject: | Re: Looking for a good repair shop |
Check with GDE first. DOC |
|
| Author: | Hexus [ Thu May 02, 2013 4:21 pm ] |
| Post subject: | Re: Looking for a good repair shop |
If you are normally within the borders of the Lower Peninsula of Michigan and didn't take your CRD to Green Diesel Engineering, you are doing yourself a great disservice. I wish I lived in Michigan when I had my problems. |
|
| Author: | jburford [ Thu May 02, 2013 9:19 pm ] |
| Post subject: | Re: Looking for a good repair shop |
I contacted Keith at GDE first. He does not do service and would not make a recommendation either. |
|
| Author: | DOC4444 [ Thu May 02, 2013 9:50 pm ] |
| Post subject: | Re: Looking for a good repair shop |
I guess he has "retired" from working on customer CRDs. He (or his people) used to do timing belts, etc. DOC |
|
| Author: | geordi [ Fri May 03, 2013 12:51 am ] |
| Post subject: | Re: Looking for a good repair shop |
Sadly, he might not be doing service anymore because someone declined to return his timing tools to him from the rental service. Very sad commentary on our community, and a big reason why I don't mail my tools out either. I did it once, but I don't think I will do that again. At this point, I think I will be selling them as I have enough other special tools and knowledge that I feel confident in doing the timing on a CRD with VW TDI tools. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|