LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

How many hours labour to change the rear crank seal?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=79123		 Page 1 of 1
Author:  steve@offroading.net [ Sat May 17, 2014 5:01 pm ]
Post subject:  How many hours labour to change the rear crank seal?
Rear crank seal has gone on our 2.8 auto, any ideas as to the hours required to get it swapped? Need to decide if I am going to get a garage to swap it or not.

thanks
Author:  dieselguy [ Sat May 17, 2014 7:10 pm ]
Post subject:  Re: How many hours labour to change the rear crank seal?
:( I would hate to think about having to do mine, but id sure hate to think of what a shop would charge.
Author:  DOC4444 [ Sat May 17, 2014 7:30 pm ]
Post subject:  Re: How many hours labour to change the rear crank seal?
In the US, an average charge would be about $1200.

DOC
Author:  dieselguy [ Sat May 17, 2014 7:57 pm ]
Post subject:  Re: How many hours labour to change the rear crank seal?
:shock: ouch,,when im hurting so bad I cant stand it and scrubbing trying to get the grease off I think how tired I am of always having to fix stuff myself until I see post on here of what ppl pay to get stuff fixed.
Author:  Mountainman [ Sat May 17, 2014 8:00 pm ]
Post subject:  Re: How many hours labour to change the rear crank seal?
X2 !
Author:  jthomas999 [ Sat May 17, 2014 8:27 pm ]
Post subject:  Re: How many hours labour to change the rear crank seal?
1200, is that about 12 hours at $100?

It seems like its pull the tyranny, transfer case, tranny adaptor then flywheel to get to the rear main. I could see that being a 6 hour job.

Sent from my DROID RAZR HD using Tapatalk
Author:  tjkj2002 [ Sat May 17, 2014 8:50 pm ]
Post subject:  Re: How many hours labour to change the rear crank seal?
jthomas999 wrote:
1200, is that about 12 hours at $100?

It seems like its pull the tyranny, transfer case, tranny adaptor then flywheel to get to the rear main. I could see that being a 6 hour job.

Sent from my DROID RAZR HD using Tapatalk

Average labor rate is $125-$150 per hour for most shops.5-6 hours alone to drop the trans,then 2 or so hours to change the actual seal plus parts.
Author:  dieselguy [ Sat May 17, 2014 8:52 pm ]
Post subject:  Re: How many hours labour to change the rear crank seal?
I can see it being a pain in the a@@. the rear main is probably the most annoying thing you can ever have to replace. you have to take so many things apart that nothings wrong with to get to one seal. its about as deep as you can get. I don't think pulling a crankshaft is annoying as a rear seal.
Author:  steve@offroading.net [ Sun May 18, 2014 4:47 am ]
Post subject:  Re: How many hours labour to change the rear crank seal?
A shop owned by a friend has estimated 10 hours, I am getting mates rates on the labour at £40/hour so £400 / $700ish. Seems a better deal than you guys are getting!. I would happily do it on my WJ myself, the lift it has means its easy access, but the KJ is too low to do it without a pit or ramp.
Author:  steve@offroading.net [ Sun May 18, 2014 4:50 am ]
Post subject:  Re: How many hours labour to change the rear crank seal?
Any other jobs worth doing while in there? IFAIK it is only the rear seal that has an issue
Author:  DOC4444 [ Sun May 18, 2014 7:00 pm ]
Post subject:  Re: How many hours labour to change the rear crank seal?
Replace torque converter and/or trans pump, clutch packs, etc., if needed (assuming you have an automatic, of course.)

Make sure the surface of the crank that rides in the seal is good.

EHM will prevent you from blowing out the new rear main seal.

DOC
Author:  LS12FAST4U [ Tue May 20, 2014 12:51 pm ]
Post subject:  Re: How many hours labour to change the rear crank seal?
Labor rate will depend on where you live and if the shop is in the city or on the out skirts of town. Labor rates where I live range from 95 in town to 65 as you get a little further away.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/