Okay, I'm getting ready for the lift pump install. I've ordered the Airtex pump, now I'm looking at the wire requirements in more detail.

I don't want to order a $75-100 wire harness just to strip a couple of wires out, so I was planning on doing it myself.

Only references I've seen refer to 54001800 and 54001801 pins for Apex 2.8mm connector.

However, when I looked these up on mouser.com they say they are obsolete and have been replaced by 10757690 and 10762775??

Has anyone else tried ordering these lately? Is this the best website to order from?

Also, is new ground stud at connector the preferred grounding method?

Any good recommendations for fuel pressure gauge and best place to install it?

Thanks for all the great advice.

_________________
#1 2006 Silver CRD Limited, flipped spare tire, ASFIR skids, GDE TCM & Ecotune, blue SAMCOs, 5V glow plugs, Rotella T6, intank fuel pump, Gen2 fuel head, new crank sensor, JBA 2.5 in silver package, Provent and ARB bumper
#2 2006 Metallic Green Limited; currently DOA
#3 2005 Silver project; currently not running...don't judge me