Back together but wont start but will turn over

Brumbles88 · **Posted:** Mon Feb 16, 2015 11:42 pm

So just did the rockers and am reassembled up to the serpentine belt. I tried giving it a start but it doesn't seem to want to start.

I have bleed the filter and primed it several times but it doesn't seem to hold pressure. I checked the fuel rail and by unthreading the fitting at the front of the rail and I get about one drop of fuel. I remember reading about bleeding the rail but also have read that it should essentially bleed its self through the injector bypass. Is this something I should try?

I ordered a blue tooth OBD2 so I can check sensors using torquepro, should be here tomorrow.

Is there any reason it wouldn't start if there was no coolant? That's the only thing I haven't "reassembled" as I don't wanna waste coolant if I have to tear it down again.

Thanks for your help cant wait to have my own wheels again.

flman · **Posted:** Tue Feb 17, 2015 7:15 am

Just loosen the fitting at injector 1, crank it, when you get fuel, tighten it and start your Libby.

Brumbles88 · **Posted:** Fri Feb 20, 2015 10:43 pm

SO still no luck. Tried bleeding number 1# injector at the the injector got fuel closed it up but no start. I found fuel leaking at the 4way because i didn't tighten the hose clamp all the way but fixed that still no start. I plugged in the block heater in hopes it will help but Im not sure what else I can do.

ebbnflow · **Posted:** Sat Feb 21, 2015 12:22 am

I believe the wiring connector for injector 4 and the high pressure fuel sensor are identical and can be switched easily. Switching them will cause a no start situation. Something easy to check.

Brumbles88 · **Posted:** Sat Feb 21, 2015 1:31 pm

Tried switching the high pressure sensor and #4 injector still no luck.

Back together but wont start but will turn over

Who is online