| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Back together but wont start but will turn over http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=81377 |
Page 1 of 1 |
| Author: | Brumbles88 [ Mon Feb 16, 2015 11:42 pm ] |
| Post subject: | Back together but wont start but will turn over |
So just did the rockers and am reassembled up to the serpentine belt. I tried giving it a start but it doesn't seem to want to start. I have bleed the filter and primed it several times but it doesn't seem to hold pressure. I checked the fuel rail and by unthreading the fitting at the front of the rail and I get about one drop of fuel. I remember reading about bleeding the rail but also have read that it should essentially bleed its self through the injector bypass. Is this something I should try? I ordered a blue tooth OBD2 so I can check sensors using torquepro, should be here tomorrow. Is there any reason it wouldn't start if there was no coolant? That's the only thing I haven't "reassembled" as I don't wanna waste coolant if I have to tear it down again. Thanks for your help cant wait to have my own wheels again. |
|
| Author: | flman [ Tue Feb 17, 2015 7:15 am ] |
| Post subject: | Re: Back together but wont start but will turn over |
Just loosen the fitting at injector 1, crank it, when you get fuel, tighten it and start your Libby. |
|
| Author: | Brumbles88 [ Fri Feb 20, 2015 10:43 pm ] |
| Post subject: | Re: Back together but wont start but will turn over |
SO still no luck. Tried bleeding number 1# injector at the the injector got fuel closed it up but no start. I found fuel leaking at the 4way because i didn't tighten the hose clamp all the way but fixed that still no start. I plugged in the block heater in hopes it will help but Im not sure what else I can do. |
|
| Author: | ebbnflow [ Sat Feb 21, 2015 12:22 am ] |
| Post subject: | Re: Back together but wont start but will turn over |
I believe the wiring connector for injector 4 and the high pressure fuel sensor are identical and can be switched easily. Switching them will cause a no start situation. Something easy to check. |
|
| Author: | Brumbles88 [ Sat Feb 21, 2015 1:31 pm ] |
| Post subject: | Re: Back together but wont start but will turn over |
Tried switching the high pressure sensor and #4 injector still no luck. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|