| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| CODE U0415 http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=81449 |
Page 1 of 1 |
| Author: | mustang_gt_350 [ Fri Feb 27, 2015 5:20 pm ] |
| Post subject: | CODE U0415 |
Just pulled codes off my libby. The normal egr, and maf. U0415 Invalid Date Received From Anti-Lock Brake System Control Module. Anyone had this code? I'm 100% sure i need a new wheel bearing/hub on the passenger front. I actually have for both pass. and driver side. But its been so cold i haven't been able to put them on. I'm hoping the weather forecast is correct and i can tackle it on wed. I just wanted to know if that code could be something else? |
|
| Author: | mustang_gt_350 [ Sat Feb 28, 2015 1:03 pm ] |
| Post subject: | Re: CODE U0415 |
Just a follow up. I swapped out the passenger side hub this morning after work. Nothing beats working outside in the driveway when its 8-10 degrees because the garage is full of projects that can't be moved easily. lol Anyway the bearing was completely open in the rear and it had a huge amount of play. I have no way of resetting the ABS lights but hopefully that was the problem. I'll swap the drivers side out when its a little nicer hopefully weds. Any way other than the dealer to reset the ABS light? |
|
| Author: | papaindigo [ Sat Feb 28, 2015 1:17 pm ] |
| Post subject: | Re: CODE U0415 |
I suspect there is a decent chance that a good brake shop would have a code reader that can clear the code. On the other hand this may be one of those codes that goes away on its own after like 5 drive cycles after the problem that caused the code is fixed. |
|
| Author: | mustang_gt_350 [ Sat Feb 28, 2015 1:20 pm ] |
| Post subject: | Re: CODE U0415 |
papaindigo wrote: I suspect there is a decent chance that a good brake shop would have a code reader that can clear the code. On the other hand this may be one of those codes that goes away on its own after like 5 drive cycles after the problem that caused the code is fixed. Thanks. I'll try to reset it with the torque app but i doubt it will work. I'll see if it will go away. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|