| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| crank sensor http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=81507 |
Page 1 of 1 |
| Author: | RTTT265 [ Fri Mar 06, 2015 9:35 pm ] |
| Post subject: | crank sensor |
I think its easy to get out from below, but how do you unplug it. Dropping turbo ex manifold and shield does not look easy? |
|
| Author: | WWDiesel [ Fri Mar 06, 2015 10:01 pm ] |
| Post subject: | Re: crank sensor |
You can remove the heat shield and then the wiring harness plug and crank sensor are both easy to access. You do not have to drop the exhaust pipe to change it! Changed mine in less than 30 minutes after dropping my transmission/transfer case skid plate... 
|
|
| Author: | RTTT265 [ Fri Mar 06, 2015 10:33 pm ] |
| Post subject: | Re: crank sensor |
Yep. I was thinking plasma cutter from one end of the jeep to other.
|
|
| Author: | papaindigo [ Sat Mar 07, 2015 11:00 am ] |
| Post subject: | Re: crank sensor |
Not that hard to remove once you get access. See pics at viewtopic.php?f=98&t=74594 . Once hold down bolt is undone should pull right out although it may need a bit of wiggling. |
|
| Author: | flman [ Sat Mar 07, 2015 5:45 pm ] |
| Post subject: | Re: crank sensor |
I pushed my plug out of the metal retainer with a screwdriver. |
|
| Author: | RTTT265 [ Sun Mar 08, 2015 3:45 am ] |
| Post subject: | Re: crank sensor |
Oh is that what it looks like Can feel the cps and bolt. Just see the plug bracket Had no idea what plug looked like |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|