crankshaft position sensor on an 06 crd

_________________
06 CRD lmtd Blacked out
Renegade lightbar curt rack
moose tool boxes GDE
pinch welds ham SC t conv
3.7 fan egr del
steel glow plugs Frankenlifted
samco
gen. grab at2 30.5x10



mpg 24.6

This is my Jeep there are many like it but this one is mine!

Not to be difficult but you can't scroll down to a post from Sunday last?

_________________
Sold to LOST member my 05 Ltd, GDE Stg II turbo + TCM tune, SunCoast TC w. Transgo kit, Steiger window regulators, Samcos, Fumoto valve, 2nd gen filter head with Lub. Spec. bleeder, Hayden clutch & 11 blade fan, inverted spare, P-1 battery, BF Goodrich Long Trail TAs, Etecno1 glow plugs, timing belt at 50K miles/8 yrs

See picture below, it clearly shows the location!
There is a heat shield that has to be be removed to access the sensor. (6mm bolts, requires 10mm socket or wrench)
Sensor is held in by a metric allen bolt, 5mm allen wrench. After you remove the allen bolt, twist the senor back and forth while pulling on it, it should pull right out...
It can be changed from the underside of the Jeep by getting it up on either ramps or jack stands. Changed mine in less than 30 minutes....

_________________
Supporting Vendor and Moderator of LOST
05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount
98 Dodge Cummins 24 Valve