| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| where is the crank p s http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=81893 |
Page 1 of 1 |
| Author: | jaym540 [ Tue Apr 21, 2015 6:32 pm ] |
| Post subject: | where is the crank p s |
crankshaft position sensor on an 06 crd |
|
| Author: | papaindigo [ Tue Apr 21, 2015 8:17 pm ] |
| Post subject: | Re: where is the crank p s |
Not to be difficult but you can't scroll down to a post from Sunday last? |
|
| Author: | WWDiesel [ Tue Apr 21, 2015 9:15 pm ] |
| Post subject: | Re: where is the crank p s |
See picture below, it clearly shows the location!  There is a heat shield that has to be be removed to access the sensor. (6mm bolts, requires 10mm socket or wrench) Sensor is held in by a metric allen bolt, 5mm allen wrench. After you remove the allen bolt, twist the senor back and forth while pulling on it, it should pull right out... It can be changed from the underside of the Jeep by getting it up on either ramps or jack stands. Changed mine in less than 30 minutes....  
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|