LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

For you DIYers, Window regulator
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=82468
Page 1 of 1

Author:  synthetic-oil [ Thu Jun 25, 2015 1:53 pm ]
Post subject:  For you DIYers, Window regulator

http://www.jeepforum.com/forum/f28/how- ... r-3250833/

Author:  thermorex [ Fri Jun 26, 2015 3:10 pm ]
Post subject:  Re: For you DIYers, Window regulator

Thanks for sharing, I did this on a Cherokee and the plastic was so brittle that it held for few days. Good enough till I got a proper replacement. But that steiger performance kit is the best imo.

Author:  gmctd [ Fri Jun 26, 2015 4:04 pm ]
Post subject:  Re: For you DIYers, Window regulator

Been there, done that, plus several other attempted kludges
- results factored on state of nylon slide, whereby it's usually already brittle and disintegrating
- oem design hadta use the nylon compound because a steel slide would need constant renew-it\refresh-it lubrication, much like an electric motor with sleeve bushings
- anyone ever pulled out an older mechanism and seen the hardened lumps of paste, where the petroleum base had evaporated and left the fiber, would easily understand that scenario

Author:  dirtmover [ Sat Jun 27, 2015 9:16 am ]
Post subject:  Re: For you DIYers, Window regulator

Can't see that repair lasting too long but the good news is that you can pick up a kit to do all 4 for around $75. http://www.autoandart.com/02-06-jeep-li ... epair-kit/

Author:  JeepMorrison [ Sat Jun 27, 2015 9:34 am ]
Post subject:  Re: For you DIYers, Window regulator

dirtmover wrote:
Can't see that repair lasting too long but the good news is that you can pick up a kit to do all 4 for around $75. http://www.autoandart.com/02-06-jeep-li ... epair-kit/

Same ones i have.

Author:  Hexus [ Sun Jun 28, 2015 11:19 pm ]
Post subject:  Re: For you DIYers, Window regulator

Use the Steiger kit and be done with it.

Author:  mikey1273 [ Mon Jun 29, 2015 7:57 am ]
Post subject:  Re: For you DIYers, Window regulator

Yeah both my rear windows failed like that about 8 months apart. Ironic part is I'm a single guy and no one regularly rides in the back, the windows are very rarely down. when the first one dropped it was when I closed the door after putting an item on the back seat, second one when I hit the switch for rear passenger window when I wanted to lower the front. Both fronts have yet to fail and are up and down all the time.

I used the Steiger kit on both rear windows. It works great the first time it did take me a while and I had some trouble with broken plastic bits stuck in the end of the spiral cable tube.

Author:  jlg89 [ Wed Aug 12, 2015 10:06 am ]
Post subject:  Re: For you DIYers, Window regulator

When the driver's side rear window fell in my recently-acquired '06 Liberty, I picked up one of the 4-piece Steiger-style kits from autoandart.com (I figure all four windows will need it at some point). But when I got into the rear doors, I found that one of the POs had installed aftermarket regulator & motor assemblies, dang it. After some digging, I found the source, and wrote up a "review" of sorts, FWIW.

http://www.jeepforum.com/forum/f28/can- ... r-3350977/

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/