On any gas engine I wouldn't hesitate, but do you all think it's ok to run the engine minus the trans? hmm, and what about bolting the torque converter on for dampening? Just a recipe for a giant mess???

Ok, so I'll tell you why Already have the transmission out, and I have a slight worry that this engine could have bottom end damage...

_________________
05 CRD: H.D.S2 stat,WW Ironrock trilink&LCA's, OX rear,ARB front, 4.10's, ARB bumper, Suncoast,OME 3.5, JBA UCA,rock rails, Moabs&265/75 Duratracs, GDE tunes ,FFD fan,ARP's, 2 micron fuel, new valves,sasquatch battery tray & grid heater, tensioner relocated
Mech fan, VH & AC delete

Not my area of much expertise but I don't see how a brief run could hurt anything. Should be about the equivalent of running in neutral or park. Now whether the "system" will let it even start with the tranny and its electronics unhooked I have no clue.

_________________
Sold to LOST member my 05 Ltd, GDE Stg II turbo + TCM tune, SunCoast TC w. Transgo kit, Steiger window regulators, Samcos, Fumoto valve, 2nd gen filter head with Lub. Spec. bleeder, Hayden clutch & 11 blade fan, inverted spare, P-1 battery, BF Goodrich Long Trail TAs, Etecno1 glow plugs, timing belt at 50K miles/8 yrs

Thanks for the reply. Luckily they made the wires nice and long, so it's easy to hook the wires up with the trans on the ground, probably throw it in limp mode I'm guessing without the shaft moving, but that's no big deal.

_________________
05 CRD: H.D.S2 stat,WW Ironrock trilink&LCA's, OX rear,ARB front, 4.10's, ARB bumper, Suncoast,OME 3.5, JBA UCA,rock rails, Moabs&265/75 Duratracs, GDE tunes ,FFD fan,ARP's, 2 micron fuel, new valves,sasquatch battery tray & grid heater, tensioner relocated
Mech fan, VH & AC delete

No problem running a diesel engine without the transmission connected. done it many times.

_________________
2005 KJ RENAGADE 2.8 CRD 6 SPEED NP242 FULLTIME 4X4

Thanks, I've seen a couple run that way, but was worried about vibrations and our loose crank bearing situation

_________________
05 CRD: H.D.S2 stat,WW Ironrock trilink&LCA's, OX rear,ARB front, 4.10's, ARB bumper, Suncoast,OME 3.5, JBA UCA,rock rails, Moabs&265/75 Duratracs, GDE tunes ,FFD fan,ARP's, 2 micron fuel, new valves,sasquatch battery tray & grid heater, tensioner relocated
Mech fan, VH & AC delete

It might run rough because the lack of flywheel (torque converter). But I don't believe it will hurt the engine any.

_________________
Phil
2005 131k 3.7 Gasser (Lifted-CRD Springs, 4.10 Gears, F+R DTT, Teraflex 2wd Low, Skidrow/Mopar Skids, Rock Lizard Super Skinks, Goodyear Wrangler Authority 31x10.5-15)
2012 Triumph Tiger (TKC 80 Front Tire Heidnau K60 Rear, Crash Bars, Skid Plate, Bark Busters, Pelican Case Top Box)

thanks fellas, I'll give it a go

_________________
05 CRD: H.D.S2 stat,WW Ironrock trilink&LCA's, OX rear,ARB front, 4.10's, ARB bumper, Suncoast,OME 3.5, JBA UCA,rock rails, Moabs&265/75 Duratracs, GDE tunes ,FFD fan,ARP's, 2 micron fuel, new valves,sasquatch battery tray & grid heater, tensioner relocated
Mech fan, VH & AC delete