| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Bad Rear Ball joints, 3 bushings on V shaped metal brace http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=83651 |
Page 1 of 1 |
| Author: | Silverbullet [ Mon Dec 14, 2015 1:09 am ] |
| Post subject: | Bad Rear Ball joints, 3 bushings on V shaped metal brace |
Anyone else had these go bad? Would a CRD be the same as other liberty's? I found a write up on another forum. I found lots of metal shavings inside them and the rubber seams to be rotted out and gone. Could you check the pics and confirm this is the rear ball joint bushings?    I found this online, Seems to be the same part http://www.amazon.com/gp/product/B00B8K ... PDKIKX0DER Ben |
|
| Author: | Mountainman [ Mon Dec 14, 2015 1:26 am ] |
| Post subject: | Re: Bad Rear Ball joints, 3 bushings on V shaped metal brace |
Silverbullet wrote: Anyone else had these go bad? Would a CRD be the same as other liberty's? I found a write up on another forum. I found lots of metal shavings inside them and the rubber seams to be rotted out and gone. Could you check the pics and confirm this is the rear ball joint bushings? I found this online, Seems to be the same part http://www.amazon.com/gp/product/B00B8K ... PDKIKX0DER Ben That's the one. They go bad around 100k or so with no lift. I hear that OEM is better. |
|
| Author: | Silverbullet [ Mon Dec 14, 2015 1:32 am ] |
| Post subject: | Re: Bad Rear Ball joints, 3 bushings on V shaped metal brace |
Thanks. do you know if the OEM has all the pieces pressed in as needed? I would prefer to purchase the entire assembly. I do not have a press. Ben |
|
| Author: | Mountainman [ Mon Dec 14, 2015 12:09 pm ] |
| Post subject: | Re: Bad Rear Ball joints, 3 bushings on V shaped metal brace |
pretty sure it does. Yours is too rusty to reuse anyhow. |
|
| Author: | thermorex [ Mon Dec 14, 2015 4:52 pm ] |
| Post subject: | Re: Bad Rear Ball joints, 3 bushings on V shaped metal brace |
I got the wishbone from napa, less than 200 (140-ish couple years ago), comes with bushings and balljoint. It's same. As gassers. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|