LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Installation of 2.5 inch JBA lift. Question on end links
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=83788		 Page 1 of 1
Author:  vertrx7 [ Mon Jan 04, 2016 10:29 pm ]
Post subject:  Installation of 2.5 inch JBA lift. Question on end links
As stated in the title, we are installing the lift kit. Since the Jeep was from snow country, we have encountered/are encountering a lot of rust and stuck parts. The sway bar end links need to be replaced. They were difficult to remove.

For this size lift, can I go with stock end links or do I need to buy extended ones? I have not had a chance to ask JBA but we are in the middle of the build so need to get this together as the vehicle is going back out West end of the week...I hope!
Author:  JeepMorrison [ Tue Jan 05, 2016 12:13 am ]
Post subject:  Re: Installation of 2.5 inch JBA lift. Question on end link
Stay with stock links

Sent from my SM-N900P using Tapatalk
Author:  vertrx7 [ Tue Jan 05, 2016 10:08 pm ]
Post subject:  Re: Installation of 2.5 inch JBA lift. Question on end link
Thank you. We got some stock ones and bolts since the bolts and nuts were really corroded. The northern Winters didn't do the underside any good.
Further, my son leaned against a rust spot in the back door and put his finger through the bottom edge. Always something new...I hate rust!
Author:  funnyman06 [ Wed Jan 06, 2016 4:54 pm ]
Post subject:  Re: Installation of 2.5 inch JBA lift. Question on end link
vertrx7 wrote:
Thank you. We got some stock ones and bolts since the bolts and nuts were really corroded. The northern Winters didn't do the underside any good.
Further, my son leaned against a rust spot in the back door and put his finger through the bottom edge. Always something new...I hate rust!


Where are you located?
Author:  vertrx7 [ Wed Jan 06, 2016 9:58 pm ]
Post subject:  Re: Installation of 2.5 inch JBA lift. Question on end link
We are in South Carolina.

Finally almost got one side (Driver's) done. Removing that A arm was a bear. Doing it twice is even worse since I reinstalled it first without installing the coilover. I should have looked at the directions closer and installed the coilover first. With the weather colder and the light going away too soon, it makes the job that much more difficult. Especially for a first timer :)
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/