| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Will a gas-job ABS module work? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=84108 |
Page 1 of 1 |
| Author: | 480fiend [ Wed Feb 24, 2016 7:18 pm ] |
| Post subject: | Will a gas-job ABS module work? |
I can get a 2003 Limited KJ in decent running shape with the same transfercase as mine (selectrac) for a six or eight hundred bucks. Recently spent time at the stealership and apparently i need a new abs module. Will the one out of the 2003 3.7 work in my 2006 KJ Limited CRD; asking cause they quoted me around 500 for a used and 1000 for a new module? I know ill probably have to take it to get re-programmed or what have you anyways.... |
|
| Author: | flash7210 [ Wed Feb 24, 2016 9:26 pm ] |
| Post subject: | Re: Will a gas-job ABS module work? |
Search ebay. Lots of used ABS modules for a lot less. You will propably also find one that came out of a CRD which will take all the guess work out of it. |
|
| Author: | Sir Sam [ Wed Feb 24, 2016 10:52 pm ] |
| Post subject: | Re: Will a gas-job ABS module work? |
check car-part.com even if the part is across the country its small enough to ship inexpensively. |
|
| Author: | Mike92104 [ Thu Feb 25, 2016 12:22 am ] |
| Post subject: | Re: Will a gas-job ABS module work? |
I'd like to know why the stealership thinks you need a new one. |
|
| Author: | Billwill [ Thu Feb 25, 2016 10:58 am ] |
| Post subject: | Re: Will a gas-job ABS module work? |
I agree with Mike...why does the Dealer think you need a new module? Could be a bad/dirty wheel sensor. I believe that the module would have to be programmed to know which vehicle it is in...I was involved in a long post with an English owner who could only get a brand new ABS module to work after the new one was re-programmed. |
|
| Author: | 480fiend [ Thu Feb 25, 2016 5:23 pm ] |
| Post subject: | Re: Will a gas-job ABS module work? |
They checked the sensors and wiring to them. From what i understand the module isn't communicating/able to communicate. And its intermittent. Sometimes it'll respond to them sometimes it wont. When it did respond they saw a whole bunch of codes i guess. Sometimes the lights come on right after i start it, other times its 10 minutes down the road. And the only lights that come on are the ESP/BAS light and the traction control off light (but never the brake light). I still have abs brakes, but no traction control. The main reason I am really looking into this is because it wont come out of park. I have manually disconnected the solenoid that keeps it in park until the brakepedal is pushed until i can afford a new abs module. And, yes, i have replaced the brake switch at least 6 times. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|