LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

All back together, crank but no start
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=84464		 Page 1 of 1
Author:  Dent [ Sat Apr 16, 2016 4:05 pm ]
Post subject:  All back together, crank but no start
Been sitting for almost 3 years. It's all back together after ARPs, new timing, Weeks stage 1 and 2, TDF thermostat and a brand new AGM. It cranks, but won't start. I got codes P0070, P0093, and P0403. There's fuel at the bleeder valve, although it is nearly three years old. I guess that will be my first try, but I'm in the middle of a blizzard, so it will be at least a day before I can get fresh fuel.
Author:  Dent [ Sat Apr 16, 2016 5:06 pm ]
Post subject:  Re: All back together, crank but no start
I shot some ether in the CAC to engine hose, and it started. Ran rough, seemed like it was smoothing out, then died. There's fuel all over the top of the engine, but I am by myself, so I can't see where it is coming from. Looks like the injector return hoses are all wet. It is common for those to break down?
Author:  Dent [ Sat Apr 16, 2016 6:23 pm ]
Post subject:  Woo Hoo it runs!
It was #2 injector line was loose. It runs!! Still have CEL and codes p0070 and p0403.
Author:  Mike92104 [ Sat Apr 16, 2016 6:24 pm ]
Post subject:  Re: All back together, crank but no start
I don't think they break down. Did you get them seated properly? Are the clips in properly? Did you use new copper washers when you installed the injectors? Did you clean up the injector seats?

Mike
Author:  Dent [ Sat Apr 16, 2016 7:48 pm ]
Post subject:  Re: All back together, crank but no start
Mike,

Yes to all your questions. The hard line to injector #2 was loose. It's running now.
Author:  Dent [ Sat Apr 16, 2016 7:49 pm ]
Post subject:  Re: All back together, crank but no start
All codes except for p0403 are gone. CEL still on.
Author:  Mike92104 [ Sat Apr 16, 2016 11:10 pm ]
Post subject:  Re: All back together, crank but no start
Dent wrote:
Mike,

Yes to all your questions. The hard line to injector #2 was loose. It's running now.


Sorry, you snuck another post in there while I was typing my reply.
Author:  geordi [ Sun Apr 17, 2016 1:04 am ]
Post subject:  Re: All back together, crank but no start
Dent wrote:
All codes except for p0403 are gone. CEL still on.


P0403 is an EGR related code. EGR circuit high voltage is what the list says, but I thought you had a GDE tune? If not, you may want one, or the Yeti tune can also delete the EGR codes from the system.

Glad to hear it is running! (Sorry I missed that injector line, I thought I had gotten them all)
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/