The locking pins and / or kits can be bought at Freedom Racing and there are also some Miller tools listed on ebay....watch out for some of the chinese junk cheap stuff on ebay though...
http://www.freedomracing.com/catalogsearch/result/?q=1052
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Need help: Looking for Timing belt tools http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=84842 |
Page 1 of 1 |
| Author: | kk3dln [ Sat Jun 25, 2016 11:04 pm ] |
| Post subject: | Need help: Looking for Timing belt tools |
I got an '05 Jeep Liberty CRD that just turned 100k miles. I got a timing belt kit from ID and I was wondering if anyone had a set of tools that they would rent or wanted to sell. I really do not want to buy a set of tools for a one time job. There are several places that rent them out, but they start about $90., that seems a little expensive to me, plus they want a $700. deposit. They can't cost more than a Couple hundred dollars. There always seems that one of the pieces is stripped, bent or worn out. If anyone can help, let me know. I am in central PA. Don |
|
| Author: | papaindigo [ Sun Jun 26, 2016 8:51 am ] |
| Post subject: | Re: Need help: Looking for Timing belt tools |
You can make the pins (see http://www.beesvillebeefarm.com/jeep.html) or in the case of the flywheel pin just use a long shank 6mm/0.25" allen key (see 05 FSM) for how to and you can buy a cam holding tool like the one in the post. NOTE there is no need to pull all the front end stuff off; just carefully remove the fan and shroud as one unit; cut the bottom half of the shroud off below the mounting tabs and throw the bottom half away as it's not needed and it makes reinstall/future removal a snap. NOTE just replace front half of water pump and "O" ring; back half has no moving parts and is a pain to get at. |
|
| Author: | 95Z28A4 [ Sun Jun 26, 2016 9:28 am ] |
| Post subject: | Re: Need help: Looking for Timing belt tools |
kk3dln wrote: There are several places that rent them out, but they start about $90., that seems a little expensive to me, plus they want a $700. deposit. They can't cost more than a Couple hundred dollars. Don Well.......actually the Miller timing tools are at least that expensive. |
|
| Author: | jws84_02 [ Sun Jun 26, 2016 11:05 am ] |
| Post subject: | Re: Need help: Looking for Timing belt tools |
I feel like this was already discussed and quite a few post were deleted. I offered my tools for rent, guess op isn't interested |
|
| Author: | WWDiesel [ Sun Jun 26, 2016 11:14 am ] |
| Post subject: | Re: Need help: Looking for Timing belt tools |
The locking pins and / or kits can be bought at Freedom Racing and there are also some Miller tools listed on ebay....watch out for some of the chinese junk cheap stuff on ebay though... http://www.freedomracing.com/catalogsearch/result/?q=1052 |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|