| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Any suggestions on getting pinch bolt out on ball joint http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=85180 |
Page 1 of 1 |
| Author: | jeeplibertycrd [ Sat Aug 27, 2016 11:56 am ] |
| Post subject: | Any suggestions on getting pinch bolt out on ball joint |
I tried hammering with brass punch |
|
| Author: | flash7210 [ Sat Aug 27, 2016 12:18 pm ] |
| Post subject: | Re: Any suggestions on getting pinch bolt out on ball joint |
You can use a pickle fork (a.k.a. Ball joint separator). But what I do is hammer the side of where the ball joint stud goes into. Usually one or two hard hits and it pops free. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|