LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

identifying fan clutch
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=86963		 Page 1 of 1
Author:  krautastic [ Tue Aug 01, 2017 11:36 am ]
Post subject:  identifying fan clutch
Is there any markings to identify a hayden clutch fan vs an oem unit? The fan clutch I pulled off looks fairly new compared to alot of the components around it, but I see no manufacturer on the unit and no marking that seems to come back as a part number.
Author:  GordnadoCRD [ Tue Aug 01, 2017 6:46 pm ]
Post subject:  Re: identifying fan clutch
Have you tested the one you pulled off? (heat in oven to like 185F) They don't lock up completely. The HD ones will turn about 80% the speed of the hub, but you can feel it tighten up. I didn't look for markings on my Hayden, but the Mopar one should have a Penta-star mark, or a part number.
Author:  mass-hole [ Tue Aug 01, 2017 8:04 pm ]
Post subject:  Re: identifying fan clutch
Not sure, I don't remember seeing any specific markings on my Hayden. I will say that my Hayden was DOA and it seems other people around here have had them die an early death


Sent from my iPhone using Tapatalk
Author:  TKB4 [ Tue Aug 01, 2017 10:29 pm ]
Post subject:  Re: identifying fan clutch
the one on my salvage jeep has STOR THIS FACE DOWN stamped on the side facing radiator the side you can see with fan blade attached below the coil

Again I don't know if this is the OEM one but I am pretty sure its not a Hayden
Author:  mass-hole [ Tue Aug 01, 2017 11:48 pm ]
Post subject:  Re: identifying fan clutch
TKB4 wrote:
the one on my salvage jeep has STOR THIS FACE DOWN stamped on the side facing radiator the side you can see with fan blade attached below the coil

Again I don't know if this is the OEM one but I am pretty sure its not a Hayden


My Hayden did say that.


Sent from my iPhone using Tapatalk
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/