LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Egr delete now coolant leak
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=87107		 Page 1 of 1
Author:  chris7488 [ Tue Aug 29, 2017 8:13 pm ]
Post subject:  Egr delete now coolant leak
After finally replacing my intecooler hoses and fully deleting my EGR I discovered a coolant leak from mostly the drivers side bottom can't really tell where is it exactly coming from but drops down on the tranny and starter but don't se any leaks above anyone have a clue ?
Author:  jws84_02 [ Tue Aug 29, 2017 8:47 pm ]
Post subject:  Re: Egr delete now coolant leak
Did you do both stage 1 and 2 deletes. Is it leaking out the plug you put in on the side of the head?
Author:  chris7488 [ Tue Aug 29, 2017 9:35 pm ]
Post subject:  Re: Egr delete now coolant leak
Yeah I installed the plug that goes on the drivers side of the block. I'm really hoping it's not a cracked head or block . This just happens after the egr delete
Author:  geordi [ Tue Aug 29, 2017 9:44 pm ]
Post subject:  Re: Egr delete now coolant leak
Did you remove the EGR from the side of the engine, or just leave it there dead? If you left it there, it is probably just runoff from the cooler draining as it sloshes around. Otherwise, a pressure test would allow you to pump up the cooling system and see where any leak may be. If the crush washer didn't get seated properly or you inadvertently left the old washer in place too, that would be an easy point for a leak.
Author:  chris7488 [ Tue Aug 29, 2017 9:48 pm ]
Post subject:  Re: Egr delete now coolant leak
Yes I completely removed all the components from the block yeah I guess that's the next step
Author:  GordnadoCRD [ Tue Aug 29, 2017 10:26 pm ]
Post subject:  Re: Egr delete now coolant leak
The plug JWS84_02 is referring to isn't in the block. When all the EGR junk is removed, there is a nipple in the middle of the head under, and behind the intake manifold. The nipple is the coolant supply from the cylinder head. It needs to be removed, and a plug of appropriate size with thread sealant, installed in that port.

See your other query thread for a couple other things to check for.
Author:  geordi [ Wed Aug 30, 2017 1:08 am ]
Post subject:  Re: Egr delete now coolant leak
GordnadoCRD wrote:
The plug JWS84_02 is referring to isn't in the block. When all the EGR junk is removed, there is a nipple in the middle of the head under, and behind the intake manifold. The nipple is the coolant supply from the cylinder head. It needs to be removed, and a plug of appropriate size with thread sealant, installed in that port.

See your other query thread for a couple other things to check for.


I would hope that he got that removed... That wouldn't be a leak, that would be a firehose!
Author:  chris7488 [ Wed Aug 30, 2017 11:38 am ]
Post subject:  Re: Egr delete now coolant leak
I did remove the block fitting and replaced with the cap
Author:  highironcrd [ Wed Aug 30, 2017 11:50 am ]
Post subject:  Re: Egr delete now coolant leak
geordi wrote:
GordnadoCRD wrote:
The plug JWS84_02 is referring to isn't in the block. When all the EGR junk is removed, there is a nipple in the middle of the head under, and behind the intake manifold. The nipple is the coolant supply from the cylinder head. It needs to be removed, and a plug of appropriate size with thread sealant, installed in that port.

See your other query thread for a couple other things to check for.


I would hope that he got that removed... That wouldn't be a leak, that would be a firehose!

hey Geordie i have some valve failures for you,..whens a good time to stop by?
Author:  chris7488 [ Wed Aug 30, 2017 10:52 pm ]
Post subject:  Re: Egr delete now coolant leak
Found a loose line that was a close one lol my tractor is back on the road running strong at 250,000 miles :BANANA:
Author:  GordnadoCRD [ Wed Aug 30, 2017 11:05 pm ]
Post subject:  Re: Egr delete now coolant leak
good deal!
Glad you caught it!
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/