Check the oil level, add as needed.
Prime the fuel filter head to get fuel to the engine.
Check air filter for oil.
Start engine and prepare for smoke.
Been there, done that:
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Rolled CRD....where to go from here. http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=87815 |
Page 1 of 1 |
| Author: | grahamclutter [ Wed Feb 14, 2018 6:10 pm ] |
| Post subject: | Rolled CRD....where to go from here. |
Recently rolled my Liberty CRD and looking for advice on where to start to get it running again. Do's and Don'ts. |
|
| Author: | flash7210 [ Wed Feb 14, 2018 7:25 pm ] |
| Post subject: | Re: Rolled CRD....where to go from here. |
I would start by doing a oil change and putting some fresh fuel in the tank. Probably should replace the fuel filter too. Get the fuel filter primed up and see if it will start. Then go from there. |
|
| Author: | Sir Sam [ Wed Feb 14, 2018 8:34 pm ] |
| Post subject: | Re: Rolled CRD....where to go from here. |
Check the oil level, add as needed. Prime the fuel filter head to get fuel to the engine. Check air filter for oil. Start engine and prepare for smoke. Been there, done that:
|
|
| Author: | Sir Sam [ Wed Feb 14, 2018 8:36 pm ] |
| Post subject: | Re: Rolled CRD....where to go from here. |
Full repair here: http://www.colorado4wheel.com/images/li ... epair.html |
|
| Author: | geordi [ Wed Feb 14, 2018 8:57 pm ] |
| Post subject: | Re: Rolled CRD....where to go from here. |
How's the body? If any part of the passenger cage has been damaged, I would be surprised if an insurance company would be willing to take on the risk. There are lots of them floating around for sale (I also have one for sale at the moment) and depending on your insurance company you could end up with money left over letting them total it and buying it back to part out, AND still picking up another one. |
|
| Author: | jdr [ Sun Feb 18, 2018 11:48 am ] |
| Post subject: | Re: Rolled CRD....where to go from here. |
grahamclutter wrote: Recently rolled my Liberty CRD and looking for advice on where to start to get it running again. Do's and Don'ts. Find a tj with a tired engine and swap the crd into it.Sent from my SM-T580 using Tapatalk |
|
| Author: | rancherman [ Sun Feb 18, 2018 12:17 pm ] |
| Post subject: | Re: Rolled CRD....where to go from here. |
did it land on it's feet? side? top? Did engine shut down pretty quick, or did it run-on for awhile? If it sat on it's side or top for any length of time, I'd make dang sure you didn't get a little oil on top of the pistons.. It don't take much to hydraulic a piston top... or out the ccv and filled the turbo. (lot depends on angle and length of time sitting askew) so HAND roll the engine over a couple of revolutions. Pull the intake hose off to look in the turbo. Does the ecm register a 'roll over' and need attention?? 
|
|
| Author: | Sir Sam [ Sun Feb 18, 2018 1:31 pm ] |
| Post subject: | Re: Rolled CRD....where to go from here. |
jdr wrote: grahamclutter wrote: Recently rolled my Liberty CRD and looking for advice on where to start to get it running again. Do's and Don'ts. Find a tj with a tired engine and swap the crd into it.Sent from my SM-T580 using Tapatalk Wow you make that sound so easy! rancherman wrote: Does the ecm register a 'roll over' and need attention?? No. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|