just wondering if someone could give me a clue as to how this clip works. don't know if you squeeze it together to remove cable or spread it apart. I need to get the old cable out to put the new one in.
thx
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| MOPAR Transfer Case Shift Cable Retainer Clip http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=88917 |
Page 1 of 1 |
| Author: | foxhunter [ Wed Jun 20, 2018 11:01 pm ] |
| Post subject: | MOPAR Transfer Case Shift Cable Retainer Clip |
just wondering if someone could give me a clue as to how this clip works. don't know if you squeeze it together to remove cable or spread it apart. I need to get the old cable out to put the new one in. thx
|
|
| Author: | papaindigo [ Thu Jun 21, 2018 6:55 am ] |
| Post subject: | Re: MOPAR Transfer Case Shift Cable Retainer Clip |
It's a retaining clip so I doubt squeezing the wings at the bottom together will release anything. I suspect you spread it apart. If it breaks the PN is 68018106aa and cost is likely under $5. FYI the plastic bushing that holds the cable end to the pin at the transfer case is PN 68064273ab also less than $5 |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|