| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| CRD TCM http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=89389 |
Page 1 of 1 |
| Author: | CRD05LIBERTY [ Sun Oct 28, 2018 6:31 pm ] |
| Post subject: | CRD TCM |
Hi Does anyone know if the TCM module is plug and play? Or does that need to be programmed? I am going to buy the transmission tune from GDE but I was going to buy a used one off of eBay and send it to GDE for them to flash. Sent from my iPhone using Tapatalk |
|
| Author: | Jay ne Ohio [ Mon Oct 29, 2018 8:31 am ] |
| Post subject: | Re: CRD TCM |
Pretty sure it is plug and play. A few years ago I pulled one out of one CRD and put it in another to see if the original was bad. It worked fine in both CRD's. |
|
| Author: | WWDiesel [ Mon Oct 29, 2018 9:53 am ] |
| Post subject: | Re: CRD TCM |
CRD05LIBERTY wrote: Hi Does anyone know if the TCM module is plug and play? Or does that need to be programmed? I am going to buy the transmission tune from GDE but I was going to buy a used one off of eBay and send it to GDE for them to flash. They are not vehicle specific, only transmission type specific. Some have installed a TCM from a Dodge Truck. Changes shift points quite a bit but can be dangerous due to overreving engine when downshifting in certain situations. |
|
| Author: | flash7210 [ Mon Oct 29, 2018 12:30 pm ] |
| Post subject: | Re: CRD TCM |
Any TCM for a 545rfe can be used. Not to be confused with the 45rfe which is physically the same transmission but programmed as a 4 speed (no 5th gear). A TCM from a 05 or 06 CRD is preferred. I’m using a TCM from a 05 Dodge Ram Hemi. Shift points are slightly different and takes a little getting used to. Also requires more right foot management. But it will shift into 5th at 48mph if I allow it to. I wish I could get more manual control of this transmission. Can’t do it without a standalone controller and more $$$$. |
|
| Author: | CRD05LIBERTY [ Mon Oct 29, 2018 5:16 pm ] |
| Post subject: | Re: CRD TCM |
Cool I’m ordering a CRD specific TCM Sent from my iPhone using Tapatalk |
|
| Author: | CRD05LIBERTY [ Mon Oct 29, 2018 5:42 pm ] |
| Post subject: | Re: CRD TCM |
flash7210 wrote: Any TCM for a 545rfe can be used. Not to be confused with the 45rfe which is physically the same transmission but programmed as a 4 speed (no 5th gear). A TCM from a 05 or 06 CRD is preferred. I’m using a TCM from a 05 Dodge Ram Hemi. Shift points are slightly different and takes a little getting used to. Also requires more right foot management. But it will shift into 5th at 48mph if I allow it to. I wish I could get more manual control of this transmission. Can’t do it without a standalone controller and more $$$$. How come you don’t do the GDE transmission tune? Sent from my iPhone using Tapatalk |
|
| Author: | flash7210 [ Mon Oct 29, 2018 6:29 pm ] |
| Post subject: | Re: CRD TCM |
CRD05LIBERTY wrote: flash7210 wrote: Any TCM for a 545rfe can be used. Not to be confused with the 45rfe which is physically the same transmission but programmed as a 4 speed (no 5th gear). A TCM from a 05 or 06 CRD is preferred. I’m using a TCM from a 05 Dodge Ram Hemi. Shift points are slightly different and takes a little getting used to. Also requires more right foot management. But it will shift into 5th at 48mph if I allow it to. I wish I could get more manual control of this transmission. Can’t do it without a standalone controller and more $$$$. How come you don’t do the GDE transmission tune? Sent from my iPhone using Tapatalk I don’t feel I need it. |
|
| Author: | CRD05LIBERTY [ Thu Nov 01, 2018 6:17 pm ] |
| Post subject: | Re: CRD TCM |
Got me a used TCM to play with. GDE trans tune here I come ![]() Sent from my iPhone using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|