LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Locks up
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=90363		 Page 1 of 1
Author:  firemunky [ Sat Aug 24, 2019 2:37 pm ]
Post subject:  Locks up
Got head and cover back on. Pins in. Belt on correctly. Pulled pins and hand turning over. Engine locks up after about quarter turn. Is there more than one small hole in flywheel for the line up pin?

Sent from my SM-N950U using Tapatalk
Author:  ebbnflow [ Sat Aug 24, 2019 4:12 pm ]
Post subject:  Re: Locks up
firemunky wrote:
Got head and cover back on. Pins in. Belt on correctly. Pulled pins and hand turning over. Engine locks up after about quarter turn. Is there more than one small hole in flywheel for the line up pin?

Sent from my SM-N950U using Tapatalk
Yes. There are several holes in the flywheel. Is the crank set to 3 o clock?

Sent from my Pixel 3 using Tapatalk
Author:  firemunky [ Sat Aug 24, 2019 4:49 pm ]
Post subject:  Re: Locks up
Sorry, nob, how do I tell? What will line up with 3 o'clock?

Sent from my SM-N950U using Tapatalk
Author:  WWDiesel [ Sat Aug 24, 2019 4:53 pm ]
Post subject:  Re: Locks up
Just as ebbnflow said, there are several holes in the flywheel.
But there is a dimple index mark on the crankshaft that should be set at 3:00 when you have the pin in the correct flywheel hole.
Note: you may have to do a little cleaning to see it!

Image
Image
Author:  firemunky [ Sat Aug 24, 2019 7:09 pm ]
Post subject:  Re: Locks up
Perfect, thanks!

Sent from my SM-N950U using Tapatalk
Author:  TKB4 [ Sat Aug 24, 2019 11:25 pm ]
Post subject:  Re: Locks up
remember we talked about this 8/9
viewtopic.php?f=5&t=90307

the pistons should all gave been at equal height when you had the head off if the pin was in correct hole at 90 degrees ATDC
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/