flash7210 wrote:
This would be for my wife’s CRD.
Stock suspension, no lift.
Doesn’t need JBA arms.
Looking through rockauto.com there are lots of choices.
Moog and Mevotech seem to be among the best.
On mine, I previously installed the Mevotech upper arms with greasable ball joints. They worked for almost 2 years until I actually lifted it. Six months later those upper ball joints were loose. I then installed the JBA arms on mine.
But for a stock suspension that will remain stock, what would you recommend?
I went with the Moog on both sides when I replaced them. So far so good, and that was back in 2014.
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited 
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve