LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

warning lights flashing on and off randomly
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=92075		 Page 1 of 1
Author:  dalebolger [ Wed Oct 13, 2021 12:07 pm ]
Post subject:  warning lights flashing on and off randomly
Ok so while driving sometimes all of my warning lights come on and go off, think party lights or strobe lights, even more rare is the jeep seems to hiccup or burb when all the lights come on and then drive normal when they are off, so it kida like he jeep is having hicups. I do have a short video, but im not sure how to post it


blinking lights.mov


dale
Author:  WWDiesel [ Wed Oct 13, 2021 12:53 pm ]
Post subject:  Re: warning lights flashing on and off randomly
To post the video, you must first upload it to a host sharing service, and then post a link on here to the video.

As to your problem, I would start by checking ALL grounds very closely. Sounds like a loose wire or bad ground somewhere.
Author:  dalebolger [ Wed Oct 13, 2021 1:01 pm ]
Post subject:  Re: warning lights flashing on and off randomly
here is a link to the video of the dash

https://youtu.be/iJCTB_EGqMQ
Author:  dalebolger [ Sat Oct 23, 2021 11:09 am ]
Post subject:  Re: warning lights flashing on and off randomly
I cleaned batter cables, cleans connections at under hood fuse box, and tested the battery still does it. Any ideas
Author:  PZKW108 [ Wed Nov 10, 2021 9:22 pm ]
Post subject:  Re: warning lights flashing on and off randomly
dalebolger wrote:
here is a link to the video of the dash

https://youtu.be/iJCTB_EGqMQ


This exactly how a dead battery in a liberty looks like !
Author:  Billybob [ Thu Nov 11, 2021 3:30 am ]
Post subject:  Re: warning lights flashing on and off randomly
What year is your CRD?

Download the Service Manuals for your KJ here...unless it is a 2004 then you need the 2003 manuals which will be close enough.

Section 8W has the wiring diagrams and the index will show where all the grounding points are located....could be a rusty or loose ground connector!

First check the Negative Battery lead going to the chassis is clean and tight both ends.

If it is a 2005 CRD there is a FCM module in the engine bay which can have a dirty connector or could be failing....all the Serial Data runs through this module! :?

www.colorado4wheel.com/manuals/Jeep/KJ/
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/