See this thread, several options covered.
One is efan for PT Cruiser.
Replacement electric cooling fan motor for Jeep CRD:
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| A/C Condenser fan question. http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=92403 |
Page 1 of 1 |
| Author: | mike71800b [ Fri Jul 22, 2022 1:53 pm ] |
| Post subject: | A/C Condenser fan question. |
My condenser fan has stopped working, has 12v on both blue wires and ground verified on black wire. Is the motor able to be taken apart to replace the brushes in without ripping through crimps on the motor case? I've not removed the fan as of yet. I see they are no longer avail through mopar.. The aftermarket fan listed on rock auto doesn't seem to fill the shroud that they show it with so, has anyone used one of these fan assemblys to comment if its the same diamater fan and if the shroud it comes with fits properly? Thanks for replies, Mike |
|
| Author: | WWDiesel [ Fri Jul 22, 2022 5:17 pm ] |
| Post subject: | Re: A/C Condenser fan question. |
See this thread, several options covered. One is efan for PT Cruiser. Replacement electric cooling fan motor for Jeep CRD:
|
|
| Author: | mike71800b [ Fri Jul 22, 2022 10:29 pm ] |
| Post subject: | Re: A/C Condenser fan question. |
Good info, think ill find a pt cruiser motor to replace it with then. Will follow up after its repaired... Thanks everyone |
|
| Author: | mike71800b [ Thu Jul 28, 2022 12:13 am ] |
| Post subject: | Re: A/C Condenser fan question. |
Just swapped in a pt cruiser fan motor part number PM9145 vdo brand. Straight swap in no adjustment or modification needed, works great and restored a/c cooling while sitting. What I found in the old motor was one of four brushes wore unevenly and put a taper into the face of the commutator. The other three brushes were fine at about half worn. Thanks to the previous thread 
|
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|