Started the fab for some sliders. At the moment its 2 peices of steel angle iron bolted through the pinch weld. I do plan on adding a strip of steel sometime in the spring time along the bottom.

Ran out of daylight before i took pics so i didnt bother getter real good ones, better shots to come tomorrow.



(*Disclaimer* - These arent meant to take striking blows from sharp pointy rocks as that wasnt a concern for the offroading that i do*)

_________________
03 Black Freedom Edition.
Full Skids
Self Installed Evic.
Self Installed Auto-dim rear view
Custom light bar.

In the works : Lift kit, courtesy entry lighting, back up lighting and rear seat lighting.

What are you hoping that they'll protect the Jeep from?

_________________
Nanette

03 Freedom with some neat stuff done to it that I learned about here.

Only purpose they are going to be meant for is to give me some kind of flat surface to slide on while going down a sharp incline.

I have no doubt they'd bend like paper if they were hit while bouncing around going through a path with a bunch of large rocks, but thats not of concern to me.

I had ripped off the little plastic peices that cover the pinch weld a while back going from a flat surface to a steep muddy incline, i had a BUNCH of this angle iron laying around and had no real use for it.

I tried them out earlier today, they did exactly what i had wanted them to do, i've got no complaints.

Will i be changing them out for actual functional rock rails sometime...yes, was building them a good way to kill a sunday afternoon with some buddies at no cost to me, definatly.

_________________
03 Black Freedom Edition.
Full Skids
Self Installed Evic.
Self Installed Auto-dim rear view
Custom light bar.

In the works : Lift kit, courtesy entry lighting, back up lighting and rear seat lighting.

Sounds like a good way to spend a day.

_________________
Nanette

03 Freedom with some neat stuff done to it that I learned about here.