LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

LIBERTY DOCTOR
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=6&t=37841		 Page 1 of 1
Author:  greenrider [ Mon Dec 01, 2008 10:29 pm ]
Post subject:  LIBERTY DOCTOR
Well its going under the wrench tomorrow for the Rusty's 2.5 coil lift and Kelly Safari MSR 245/75R16.
This is it before the lift
Image
Author:  ramlebliberty [ Mon Dec 01, 2008 10:32 pm ]
Post subject: 
post a good pic of the rustys, I'm currently debating this lift
Author:  tommudd [ Mon Dec 01, 2008 10:52 pm ]
Post subject: 
ramlebliberty wrote:
post a good pic of the rustys, I'm currently debating this lift


you know Rustys is the same spring rate as stock , and on his I see a winch hanging out there, :shock: oh well :wink:
Author:  Christopher [ Mon Dec 01, 2008 11:00 pm ]
Post subject: 
hey tom you recommend the OME HD for a winch then?
Author:  Dje Ryu [ Mon Dec 01, 2008 11:27 pm ]
Post subject: 
If the winch is to be permanent, then yes, OME HD. But that winch is in a receiver hitch and thus, only there when he goes off-road, I'm assuming.

However, having been a previous owner of Rusty's front coils, I can tell you that it's going to sit quite a bit lower after a couple of years (or less if you wheel like I do), even without a winch.
Author:  Guest [ Tue Dec 02, 2008 4:00 am ]
Post subject: 
Rusty's coils are a waste of time, IMO, even under a KJ with nothing more than a front hitch.

OME HD's ride BETTER, to boot!
Author:  Tokyojoe [ Tue Dec 02, 2008 9:30 am ]
Post subject: 
While I recommend the Rusty's 2.5" Coil Lift, as compared to other's opinions on this site since I had one and had no problems with mine, I would NOT recommend Rusty's with a steel bumper and definitely not a winch.
Author:  greenrider [ Tue Dec 02, 2008 10:55 pm ]
Post subject: 
Dje Ryu wrote:
If the winch is to be permanent, then yes, OME HD. But that winch is in a receiver hitch and thus, only there when he goes off-road, I'm assuming.

However, having been a previous owner of Rusty's front coils, I can tell you that it's going to sit quite a bit lower after a couple of years (or less if you wheel like I do), even without a winch.

The winch stays in the back compartment until i need it (front or the back) then it goes on.
Before
Image
after
Image
I like it But have some trimming to do
Image
Author:  tommudd [ Tue Dec 02, 2008 11:01 pm ]
Post subject: 
trimming
and
BUMPSTOPS
Author:  greenrider [ Tue Dec 02, 2008 11:21 pm ]
Post subject: 
tommudd wrote:
trimming
and
BUMPSTOPS

yes in the front of the wheels where the little doors are to get inside the bumpers and on the sides where the inside of the tires rub at sharp turns.
bump stops will be Tarraflex .and i dont know about the rear bumpstops yet. i wont wheel it or flex it till i get them.
I just got it on tonight and have not had a change to deal with the rubbing yet.
It doesn't hit the pinch welds though.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/