| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Locker Switch Mod http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=69&t=11473 |
Page 1 of 1 |
| Author: | WV(0)IIIIIII(0) [ Thu Aug 17, 2006 11:30 am ] |
| Post subject: | Locker Switch Mod |
Well I got my locker switch mod done. It was easy and allows me to use my lockers without switching to 4low |
|
| Author: | 05kjrenny [ Thu Aug 17, 2006 6:04 pm ] |
| Post subject: | |
is it hard to do ? safe or warrenty friendly mod? |
|
| Author: | longarm [ Thu Aug 17, 2006 10:02 pm ] |
| Post subject: | |
.......... |
|
| Author: | WV(0)IIIIIII(0) [ Fri Aug 18, 2006 8:12 am ] |
| Post subject: | |
Very easy and it is easy to take off for service. I will try to find the write up, but here is the quick version. Remove the center consol by pulling out on the bottom (I did not take it all the way off) Take out the four screws holding the switch plate. If you unplug the switch and hold it the same way it was plugged in in front of you. Put a small jumper in the back side of the plug, on the very left wires top and bottom, I have it rigged right now but I am going to tare it back apart and use a real jumper wire. The kind that just clips into the wires. This mod will still leave the safteys in place, not locking over 10mph and shutting off over 45mph. |
|
| Author: | 05kjrenny [ Fri Aug 18, 2006 5:05 pm ] |
| Post subject: | |
theres so many confusing post about the mod over on the R.O.F. but the sums it up for me!! thanks |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|