| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Pops out of 4wd http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=69&t=59038 |
Page 1 of 1 |
| Author: | GeoJeeper [ Sun Feb 20, 2011 10:55 pm ] |
| Post subject: | Pops out of 4wd |
Test drove another Wrangler today. A 97. Liked it very much, except for the fact that it popped out of 4wd. It would go into 4 hi and stay in for a bit, then seem to slip out. In 4 lo, it would immediately pop out. Going into 4 lo, it acted like I couldn't quit pull the handle far enough to fully engage. Just enough, then pop right out. Anyone know what might cause this? I tried the search, but didn't find what I was looking for. Thanks in advance. |
|
| Author: | JJsTJ [ Sun Feb 20, 2011 11:41 pm ] |
| Post subject: | Re: Pops out of 4wd |
was it lifted? |
|
| Author: | GeoJeeper [ Sun Feb 20, 2011 11:44 pm ] |
| Post subject: | Re: Pops out of 4wd |
Nope. Appeared to be completely stock. |
|
| Author: | JJsTJ [ Sun Feb 20, 2011 11:47 pm ] |
| Post subject: | Re: Pops out of 4wd |
id suspect the transfer case linkage is worn or out of adjustment. If it had been lifted or the transfer case had been lowered i'd guess it needed to be adjusted from moving the transfer case down. |
|
| Author: | GeoJeeper [ Sun Feb 20, 2011 11:57 pm ] |
| Post subject: | Re: Pops out of 4wd |
If I'm googling the right thing, which I believe I am, it appears to be a pretty easy fix. And not too expensive. What do you think? |
|
| Author: | curt7088 [ Thu Mar 10, 2011 3:06 am ] |
| Post subject: | Re: Pops out of 4wd |
I had the same problem at ECS last year, for a while i just borrowed a bungee from bugnout and hooked it up so it wouldn't pop out, then after getting hung on some rocks and bouncing it a little it started working fine! lol so try getting it hung on some rocks... |
|
| Author: | Ajamant [ Sat Sep 03, 2011 9:38 pm ] |
| Post subject: | Re: Pops out of 4wd |
Normally This happens with lifted jeeps. Had same problem on my TJ after I lifted. Get under vehicle and locate the shifter linkage from the tub to transmission. It will have a section that can be adjusted with a flat head set screw. Simple as that. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|