LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Need pic's of..
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=73&t=43358		 Page 1 of 1
Author:  JeepBumm68 [ Wed May 20, 2009 1:49 pm ]
Post subject:  Need pic's of..
Hey everyone with the SFA i need some close up pics with different angles of the crossmember that had to be made adn anything else like brackets that were added on so i can show my shop and get the processing rolling on the SFA swap.
Author:  JJsTJ [ Wed May 20, 2009 2:17 pm ]
Post subject: 
Depending on what parts you are using, you can snag lots of pics from my build thread. It shows Nth parts but some of the work is similar enough to point them in the right direction.
Author:  JeepBumm68 [ Wed May 20, 2009 2:20 pm ]
Post subject: 
ok i have a few from allyrands, and he was using nth stuff, really just looking for a good detailed shot of the crossmember, and how the steering is mounted up.
Author:  JeepBumm68 [ Wed May 20, 2009 2:26 pm ]
Post subject: 
Hey JJ think you can get some better close up's of the mounting system for the arms on the unibody?
Author:  JJsTJ [ Wed May 20, 2009 3:11 pm ]
Post subject: 
JeepBumm68 wrote:
Hey JJ think you can get some better close up's of the mounting system for the arms on the unibody?


They will only do you good if you are using Nth parts since they are unique to them. In my build thread there are several pics showing how it all works.

here are some of them:

Image
Image

Image
Image
Image

Not sure I can get much closer or detailed than those w/ it all buttoned up now but LMK if you want me to try to capture anything else.
Author:  JeepBumm68 [ Wed May 20, 2009 3:23 pm ]
Post subject: 
Thanks JJ. i found those reading through the 17 pages of your build. haha. Another question i have is did they box in the unibody to mount those and you said they stiched welded the box onto the unibody, but did you also tie it in with bolts?
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/