|
Will having tires of the same size, but different weights, cause any problems?
Here's my situation. I'm getting a set of Moabs with 1 new MTR and 4 worn MTR's, one needing patched/plugged. I'm not really buying them for the tires because I'm not lifted yet and do not plan on running MTR's once I am.
So if after I'm lifted I buy a set of say 245/75/16 Destination AT's (about 40lbs each & 30.4 in.) would it be OK to keep one of the MTR's as a spare? The new MTR would be 50lbs and 30.7 in, while the worn tires would be roughly the same weight, but probably closer to the same size of 30.4 in. I'd lean towards keeping a worn MTR because I'm only doing a OME/Rancho lift and would be afraid of serious rubbing if I got a flat in the front.
If I kept a worn MTR as a spare and I got a flat on a rear tire, would it harm anything to run one 40lb tire and another 50lb tire together on the rear axle until I got the tire fixed?
If I kept the new MTR as the spare, would running it at 30.7 in. to 30.4 in. for the AT and 50lb to 40lb hurt anything?
Just asking to see if I can save some cash when it's tire time, being I'm getting some tires with the Moabs I'm buying anyways.
_________________ 2005 KJ Renegade
2.5" Coil Lift
OME HD Coils
Front - Rancho RSX's, Rusty's strut plates, Custom 1/4" Clevis Spacer
Rear - OME-N132L shocks, Daystar bump stops
Al's Arms & Moog LBJ's
245/75/16 BFG KO's on Moabs
AMSOIL
Husky Liners
Mopar Seat Covers
Mopar Rock Rails & Skids
|