| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Spacers-what thickness to use to avoid grinding OEM studs? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=8&t=25968 |
Page 1 of 1 |
| Author: | fasthid [ Mon Oct 29, 2007 6:07 pm ] |
| Post subject: | Spacers-what thickness to use to avoid grinding OEM studs? |
I may try a set of 1" or 1.25" spacers to set out our factory 6 spoke 16x7's so they are flush with the fenders. what thickness of spacer lets you avoid having to grind down the length of the original wheel studs so they don't prevent the whell from seating flat onto the spacer, is 1" thick enough? |
|
| Author: | tommudd [ Mon Oct 29, 2007 7:11 pm ] |
| Post subject: | |
just go with the 1.25 spidertrax and you will be fine, it will sit the tire out to almost the edge of the fender |
|
| Author: | _UnLiMiTeD_ [ Mon Oct 29, 2007 8:01 pm ] |
| Post subject: | |
hmmm......my tires stick out to the fenders basically having 255's..imagin another inch out...that look sweet.... |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|